My computer fell out of the car on its bottom closed. got it home plugged it in it started up great when it got to running the screen went dark. not sure what could be wrong

most likely damaged the panel. Recommend replace unit as panel if available may not be cost effective.

As soon as your iPad starts acting strange, it is time for a reset.

you can do this by simply closing all running apps. Press the home button twice and then swipe all apps up. They are closed then.
If all apps are closed, press the on / off button and keep it pressed till it says swipe to shut down. Swipe and wait till everything is out.
Then press the on / off button again, for a second or so. The iPad starts again.
Somewhat drastic, if you can't switch it of the normal way: Press and hold both, the on / off button and the home button, till the screen goes dark.Then the apple loge appears and again wait till the screen is dark. After that you can switch on again.
If it still does not work, goto settings then general then scroll to the bottom, where it says reset. then reset network settings. It will reset your network settings, but also the rest of the iPad. This is the most dramatic reset, without loosing your apps and documents.
One step further will wipe your data too, so that you must keep for the worst case and only after you are sure you have a backup on your computer from all your data.
Apps can be restored from the App store for free, if you have payed for them, but the data, unless you have backups, will be lost fro ever.

sounds a bit like a fuel flooding problem

Try (on the bottom of the laptop) removing the door to the RAM, and pulling one stick out at a time, than starting it, and than the other stick, and starting it. If you still have a black screen, than the motherboard has gone.

sounds like the light bulb inside the LCD screen broke its hair thin and very fragile will have to replace screen could be more expansive than a new laptop.

YES...! After holding switch in up pos for 10 seconds, it went dark. Then I performed normal start up of Fuze (Holding switch for 1 2 seconds and it started up normal with display and is now recognized.

This problem ocurred when I left the unit plugged in to USB and closed lid of my laptop overnight. ( Laptop set to go into suspend mode)

Great help, thanks.!

There are 3 parts to standby. Your version of windows must support it. You have the utility enabled and working. The display switch must be operating.

If you have checked the power utility setting and are sure they are right and the utility is installed operating right then your problem is the lid switch.

On some models you can see it under or along the bottom edge of the screen. To check if it is working use something like a tooth pick to depress the switch. The display should at least blink out when fully closed. If you can't find it or get at it you can close the display and try to spot any light coming from the screen. It should be easy to see but if nothing else try a dark room. The display should go dark as the lid closes fully. It will be pretty close to when its down so can be hard to see when.

If the display is working after you close then the switch needs replacement. If it goes dark then I would reinstall the power utility as something may have got corrupted.

i recommend checking out your plugs and wires. If you take out any of the spark plugs look at their condition and compare them to each other if there is one darker or wetter than the others that is the one that is misfiring causing the vibration and difficulty in starting.

this hapeened due to the fialure of a thn light placed in the screen . it cn be replaced but it cost more. its a flurocent like tube placed in the screen provided in the top of screen

Symptom: NO PICTURE
Cause: DEFECTIVE 3D/YC COMB FILTER
Symptom: DARK PICTURE
Cause: DEFECTIVE 3D/YC COMB FILTER
Symptom: DARK PICTURE
Cause: DEFECTIVE C724