I'm trying to find an oven door handle for a Jenn-Air model #88370 part #12001222. The part has been discontinued. Do you know of a handle that might work in it's place or perhaps a company that has old or used parts for Jenn-Air? Thank you.

It's faulty and in some sort of self protect mode. You need a service call or you can try some of the fixes here.

FIXED - WW2780 Jenn-air oven keeps shutting off ...

www.applianceblog.com > mainforums > threads > ww...

Feb 15, 2012 - Hi.... I have a Jenn-air oven model WW2780 that keeps shutting off after being turned on, almost always during the preheat. From what I have ... Missing: WW27430P ‎' Must include: WW27430P

Jenn Air Range Stove Oven - Oven Won't Turn Off - Repair ...

www.repairclinic.com > RepairHelp > Jenn-Air-Oven-...

Here are the most common reasons your Jenn Air oven won't turn off - and the ... Enter model number to search for the required part specific to your product.

HOW-TO: Jenn-Air Oven WW27430P Door won't close

www.appliancepartspros.com > repair-help > ww27430...

Door won't close is the most common symptom for Jenn-Air WW27430P. ... I have a Jennair jjw9630cas double wall oven, and after a few years I noticed that the light would not go out, first in the bottom ... Door pulls shut and li8ght stays off.

HOW-TO: Jenn-Air Oven WW27430P Won't start or doesn't start

www.appliancepartspros.com > repair-help > ww27430...

How to Replace Oven Temperature Sensor Kit for Jenn-Air WW27430P Won't start # ... Jenn Air stove JDS9860CDB00 error code 1d11 oven not shutting off. ... Very easy on this and other models with this sensor-- just two screws holding it in ... Rating: 5 · ‎123 reviews

..

Try unplugging it if it's wired directly find the circuit breaker and kick it off for a minute.

Have you contacted Jenn-Air?

If your Jenn-Air model JES9750AAW oven door is squeaking, especially when heated, it could be caused by a variety of factors. Here are a few suggestions for fixing the problem:

1. Check the hinges: Make sure that the hinges are not bent or damaged, and that they are securely attached to the door and the oven. Tighten any loose screws, and make sure that the hinges are properly aligned.
2. Lubricate the hinges: If the hinges are not damaged, try lubricating them again, using a high-quality lubricant specifically designed for oven door hinges. Some examples are silicone lubricant, white lithium grease, or PTFE spray lubricant. These lubricants are heat-resistant and can withstand high temperatures.
3. Check the door gasket: The door gasket is the seal that runs around the edge of the door and helps to keep the heat inside the oven. Make sure that the gasket is not damaged or worn, and that it is securely attached to the door. A damaged gasket can cause the door to not seal properly and cause the squeaking noise.
4. Check the door handle: Make sure that the door handle is securely attached to the door. If it is loose, it can cause the door to not sit flush against the oven and cause the squeaking noise.
5. Call for service: If none of the above solutions work, it may be necessary to contact a professional technician to take a look at your oven and diagnose the problem.

It will be the oven element that has failed, a new one wiil need to be fitted.

It is located at the rear of the oven compartment behind a removeable cover.

I hope this helps.

There are several models of Jenn-Air ovens that had issues with the door closing. The only solution is to replace the door hinges (unless the doors themselves are bad, you can see this if you open the door, the porcelain on the door will be bulged and cracked right where the hinge joins the door). If the doors are bad, the hinges and the interior door panels need to be replaced. Hope this helps!

This is a known issue. The model number is JJW9530C. I have been browsing the internet trying to find stronger hinges but with no luck. It seems there are a lot of unhappy Jenn air owners. You are correct in your assumption that the door is to heavy for the hinges. I will post the websites for your review

http://www.ovensworld.com/jenn-air-jjw9530c-expressions-collection-electric-single-oven.html

Maybe if I could see the hinge I could fabricate a stronger stainless steel one for you

The lock motor may have failed. Most often, bending a coat hanger into a hook and sliding from the right side as you move the door to the right,will allow you to release the lock and open the door.

try to open the door see if the door latch is extended if it is locate the light switch on the oven cavity and hold it in then hit start then cancel or stop the latch rod should go back

I posted a message on 12/27 and since then I have contacted Jenn-Air again and as I mentioned above the two things they told me to do didn't work, so I looked at the schematic of the unit and there appears to be a motor that locks and unlocks the door. I have a service repair coming this Saturday and seems to believe the motor is bad. Trenatru are you getting an error message? I was told by Jenn-Air that there is a 6 yr. warranty on electrical parts so will try to keep you posted if that is the cause. If you havn't tried shutting off the power try that first. They said keep it off for a couple minutes before turning back on. If that try pushing on the door and hitting cancel twice. If those two things don't work, will let you know what I find out next weekend.