Question about Voyetra Turtle Beach Turtle Beach Ear Force X1 Headphones

1 Answer

When i turn my xbox on it say on the screen e74 an one red light is on

What do i need too do

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 13,433 Answers

Powersupply failure, contact your dealer.

Posted on May 31, 2008

  • 2 more comments 
  • Ekse May 31, 2008

    this can also mean



    E74: There is high chance it's a scaler chip problem (the "ANA" or "HANA" chip near the AV cable connection) it can also be caused by a faulty AV cable so check that first. In some cases it is a problem with the GPU and may be repairable by doing the x-clamp replacement (see error 0102)

  • Ekse May 31, 2008

    But in any case its a hardware problem and you have to contact your dealer if you have warranty your saved.

  • Ekse May 31, 2008

    Heres what microsoft says about the error


    I hope this comes out readable.


    Xbox 360: One red light flashes on the Ring of Light and you receive the "E74" error message


    SYMPTOMS
    loadTOCNode(1, 'symptoms');

    When you perform an auto update on the Xbox 360 console, and then restart the Xbox 360 console, the lower-right quadrant of the Ring of Light (RoL) flashes red. Additionally, you receive the following error message:
    E74. System Error. Contact Xbox Customer Support.


    CAUSE
    loadTOCNode(1, 'cause');

    This behavior occurs when the Xbox 360 console experiences a hardware failure.


    THINGS TO TRY
    loadTOCNode(1, 'whattotry');





    1.
    Turn off the console, disconnect all the cables, and then reconnect all the cables. Turn the console back on.

    2.
    Turn off the console, and then disconnect any accessories that are connected. For example disconnect any Xbox 360 controllers, Xbox 360 Memory Units, and the Xbox 360 Hard Drive. With the accessories disconnected, restart the console to see whether the problem continues to occur. This can help determine whether the console or an accessory is experiencing the problem.

    3.
    If you continue to experience this problem, contact Xbox Customer Service.

    Note If the agent cannot help you resolve this issue, you may have to return the console to Microsoft for repair.

  • Ekse May 31, 2008

    okey that didn't come out very well, you can read what microsoft says about the problem here



    http://support.microsoft.com/kb/941377

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

THE SYSTEM IS CONNECTED DIRECTLY INTO THE RECEIVER THAN INTO THE MONITOR. AS FAR AS I KNOW IT IS NOT CONNECTED TO MY INTERNET.


one thing that you can do is turn on the auto login feature if the screen goes blank or the login session times out. I am not aware of any reason why the system would time out. The auto login setting will log you in in the event your screen goes blank.

Jan 08, 2017 | The Audio Players & Recorders

1 Answer

Pioneer media receiver pdpro6u shut off and won't turn on,now there is a blinking blue light


Check and replace the damaged component/s at its audio output stage circuit. An IC short or like that can cause this fault. If you wish to get some details; visit the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ Search the site by type in the "brand name" of your device, in the "Search box at the top right of the Homepage" to get gathered related posts.

Jan 08, 2017 | Pioneer Audio Players & Recorders

1 Answer

I have a m4500 creative speaker the problem is the volume switch when i turn it on the green light is on and when i increasing the volume the become dimmer until its off and no sound,what is cause?


It sounds like the output IC (the amplifer) has a problem.This needs to be replaced.
ELECTREPAIRUSA@ELECTREPAIRUSA or you can contact us at that address as we repair/renovate all items electronic and electrical old and new.

Mar 12, 2016 | Audio Players & Recorders

1 Answer

I have a Toshiba Satellite A665-S6088. The last time I used it was last night and everything worked fine. It works with Windows 8.1, it has for a few months now, never had any problems until now. No...


Unplug the unit from ac power. Remove the battery. Wait a minute. Press and hold down the power button for 30 seconds. (Yes, I know, nothing will happen visible). Replace battery. Plug unit back in. Now try the power button and see if the unit resets. Sometimes this helps when all else fails especially with a computer which has "hung up" like yours. Let me know if this worked!

Aug 26, 2014 | Audio Players & Recorders

1 Answer

Why does blue light keep flashing when my HMDX boom box is turned on


clip_image002.jpg if it is a slow flashing that means it is connected
if it is a fast flashing that means it is pairing
4d93f321-08ac-45e4-9e2e-bb627f3dc9ef.jpg

Jun 01, 2014 | Audio Players & Recorders

2 Answers

Hi,Just purchased 2 antec gain Bluetooth receivers type bxr 100. Operating instructions are not included. Maybe it's just me, but i'm not succeeding in getting them to work. No lights at all when they


Make sure that the unit is fully charged by a micro USB the light on it will be red until it's fully charged put phone in search mode and press the center button until the light flashes red and blue after the phone finds it you should have an option to auto pair when it's not in use it will turn off when paired and working pressing either track button will start the music player then just play with the buttons and see what it does you can stop anything from the phone controls

Mar 18, 2014 | Antec BXR-100 Gry Audio...

1 Answer

HMDX Jam wireless speaker cannot be paired with my computer


Go to your Bluetooth settings, go to the "Audio/Video" tab, under the "Content Protection" section uncheck the "Connect to content protection enabled headset only" and your bluetooth speaker(s) should now work.

hmdx-jam-wireless-speaker-cannot-paired-545ferrkqkuowltb2dothasu-3-0.jpg

Feb 02, 2013 | Audio Players & Recorders

1 Answer

The feedback on my stereo is very muffled.


Does is sound this way with all audio inputs? You might have your speaker wires backwards Red to Black between the speakers and the Stereo, make sure they are red to red and black to black.

Oct 18, 2012 | Audio Players & Recorders

Not finding what you are looking for?
Voyetra Turtle Beach Turtle Beach Ear Force X1 Headphones Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Voyetra Turtle Beach Audio Players & Recorders Experts

kakima

Level 3 Expert

101711 Answers

 Grubhead
Grubhead

Level 3 Expert

4767 Answers

The Knight
The Knight

Level 3 Expert

71754 Answers

Are you a Voyetra Turtle Beach Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...