Images are double... not focused. I have auto focused and tried all I know to fix problems... with no results. Thanks for your time

HI there blurry image came for 2 reason. 1. Lens not adjusting or focusing properly. 2. Sensor damage or your setting is on Macro / close up mode.
Just try this first and let me know. Set the camera as AUTO mode with flash and then take a day time photo. if that photo came blur then clean the sensor & lens external body and try again. If again the result same then you need to repair the lens settings. Thanks.

Hi, Try the auto convergence or auto focus to eliminate the problem, if this does not work, you may have to get the TV repaired, the common problem are the power amplifiers that correct the color convergence, that is why you get color shades or ghosts in the images.

This tv have convergence problems.Ur tv convergence board the 2 STK convergence ICS are defective,and some or all it resistor are dead.Try website like Tvrepairworld.com to buy a whole refurbish convergence board for the replacement.Spend about $100 dollars more this tv can be save.

You need to replace both convergence ICs they are STK392-110. You can get replacement Ics with free instalation instructions with pictures at the following link
http://servicemanuals.vstore.ca/

double check that its still in auto focus, i went a whole day trying to figure out why my camera wouldnt focus, and i had auto focus off

It looks like you may to replace the convergence units. It will require repair.

Hi you have bad convergence ic stk modules ,Cost for repair center to fix is 250.00. call your local repair center ask there prices on convergence ic repair. It is a very common problem every 3 to 5 years .Our service center does a lot of these.


thanks doctor video 1987

Either the convergence chip has gone bad or the Focus block is bad. In any case,you will need to consult with a professional technician to solve this problem

You will need to repair the convergence circuit to fix the double image. The second issue of the "perfect focus" stopping at 37% will be fixed at the same time. It is halting because the sensors detect no movement of the blue image. here is a link to the part number and how to purchase the board. http://www.partstore.com/Part/Samsung/Samsung/BP9500142E/New.aspx

it´s pretty normal on that camera model, there was a problem on the focus system and they are fixing it when u send to a repair centre, they just don´t say it, but once u send it they will repair it, and will be fine.