Question about Navman PiN 570 GPS Receiver

1 Answer

Pin 570 not charging

Never had a problem and then today it just wont charge.
Tried the three other chargers 2 car chargers and the mains one with no luck.
Could it be the battery?
Even if it is shouldnt it still be able to operate?
Down to 37% as I write this so enough to back it up.....I hope.

Posted by on

  • Will1985 Jun 25, 2008

    My Navman piN 570 will not turn on even with the charger plugged in. I have looked to ensure that my hard reset switch is too the right, but their is nothing there.

    I assume that this has broken off. but don't know if it broken off when at the left or the right?


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

The connect where it plugs in is very flimsy you may need a new one. try adjusting the angle etc at which you place the unit on charge its very fiddly to get it right and a small nudge loses it

Posted on Nov 07, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

TomTom Rider unit wont charge. Tried mains charger, USB connector and bike charger. Swapped out the battery and the unit boots up but that is just the charge in the new battery. Any help appreciated.

Power board is faulty, repair or replace. Workshop repair required. Oh, stop plugging a charger into the USB socket. It doesn'tlike it, thats for data transfer only. The round pin socket is the charger port

Oct 30, 2013 | Tomtom RIDER GPS Devices

1 Answer

Today i turned on my garmin after a few months, it was working will for about 2 min, then it lost satellites, so I turned it off, then tried to turn it back on, but it never turned back on. the battery...

If the GPS's internal battery is allowed to discharge too far, it will not be possible to recharge with the card charger, until it is brought up to a certain level. Connect the nuvi to a computer with USB cable overnight. This will trickle charge the internal battery to a level that will allow the car charger / cradle to keep the GPS charged from that point on. Anytime the car charger fails to recharge the internal battery, the USB charge method will have to be performed first.

Oct 21, 2009 | Garmin nuvi 200W GPS Receiver

2 Answers

Tomtom wont charge.

If it is charging via a USB connection on your computer there is nothing wrong with the TT. It doesn't matter if you are trying to charge via USB, mains, or car charger the connection is the same for all in your TT. I would look elsewhere for the problem. More than likely your car charger is faulty.

Jun 07, 2009 | Tomtom ONE GPS Receiver

1 Answer

Won't Charge

You need to change the battery. It is not a fun thing to do. Do a word search for Navman PIn 570 Replacement battery either on Google or Ebay. You have to disassemble the unit to get to the battery that is taped to the unit's motherboard. There are hidden screws on the back of the unit, then you have to gently pry the 2 halves off. Big Heads up here: the round dial on the left sure to tape that in place when you first disassemble the unit, otherwise it falls out into 2 or three pieces...that dial is a pain to get back together if you do not tape it.

I recently replaced the battery on my unit. There are two additional screws on the back of the unit, near the bottom in addition 2 screws under the flip up antenna. They are covered by small black plastic discs which need to be pried off first. After removing the rear cover with a knife edge (or similar) there are several other screws which attach the circuit board to the front of the unit which need to be removed. Note that the one near the edge should only be loosened, and the board slid out sideways. Once this has been done you should be able to access the battery which needs to be pried off the board, as it is attached with an adhesive patch.

(If the battery is totally dead it takes about a day before the charge led starts flashing.)

May 20, 2009 | Navman PiN 570 GPS Receiver

1 Answer

Pocket pc navman 1022 charger and charger jack pin

sir, i have pocket pc 1022 navman pin 570 is not connecting with my pc.

May 16, 2009 | Navman PiN 570 GPS Receiver

1 Answer

Zumo wont accept 12v charge from car or bike !

Did you drain the battery completly? Have you tried another battery yet? I've come across this issue once, seems the owner drained the battery completly. Leaving it hooked to the mains with the mains charger for almost a day did solve the issue. I'd try a new battery first.

Oct 19, 2008 | Garmin zumo 550 GPS Receiver

2 Answers

Charging socket on navman pin 570 has come out

These sockets are on sale if you google enough. Ebay seller totalviews for example. Check its the right socket and be prepared for very small presise soldering. when you open the case, take great care not to break/dismantle the rocker switch that protrudes as it has minute elements in it. If charging is a problem but the socket appears sound,m check the plug that goes into it and ensure the springs go in and out to hold it in place.F4therchristmas

May 19, 2008 | Navman PiN 570 GPS Receiver

2 Answers


maybe there is a flat or stuffed lithium battery or battery charging circuit in the pin 570.
leave unit to charge for 24 h
if the battery still dosnt charge because it is over discharged, then you may be able to push some charge in it after the battery is unplugged, after opening the case, and removing the circuit board

Jan 23, 2008 | Navman PiN 570 GPS Receiver

2 Answers

Cant get the menu display on my pin 570

maybe there is no memory caused by a flat or stuffed lithium battery or battery charging circuit in the pin 570.
leave unit to charge for 24 h
if the battery still dosnt charge because it is over discharged, then you may be able to push some charge in it after the battery is unplugged, after opening the case, and removing the circuit board.

Dec 03, 2007 | Navman PiN 570 GPS Receiver

1 Answer


Low or flat battery. Connect to mains charger and fully charge.

May 27, 2007 | Navman PiN 570 GPS Receiver

Not finding what you are looking for?
Navman PiN 570 GPS Receiver Logo

Related Topics:

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Navman GPS Experts


Level 3 Expert

66602 Answers

The Knight
The Knight

Level 3 Expert

71144 Answers

Neil Gossage

Level 1 Expert

4 Answers

Are you a Navman GPS Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides