Question about HP Pavilion dv1000 Notebook

4 Answers

Water spilled in laptop and it won't come on at all , is there any hope for it

My little boy poured a large amount of water in my laptop is there any hope for it to be repaired?

Posted by on

4 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 502 Answers

You can try to open it and clean the corroded parts on the logic board with a brush and alcohol or hydrogen peroxide. If that doesn't help, there are logic boards available on ebay and guides that will show you how to open your ipod replace the logic board. I work for a Laptop repair shop in NYC and deal with this scenario frequently.

Posted on Mar 14, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 139 Answers

I think all u need to do is lose it clean the mother boead with menthylated spirit dry it on the sun and then couple it back thats all it should work well iv done a great deal that way. if u cannot do it yrself then take it to a technician near yu. theres hope for yr notebook so dont beat the child ok.
thank u
heres some disassembling notes that can help u as a biginner

http://www.laptoprepair101.com/

http://repair4laptop.org/disassembly_hewlett_packard.html
u come back to tell me the latest ok

Posted on May 30, 2008

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 19 Answers

If it didn't blow sparks and it was just water, remove the battery and put it in a nice warm and dry place to dry out completely and then cross your fingers. There is not really anything inside a laptop computer that water just by itself will damage, but if it was on and the water shorted something out you could have problems. If after letting it dry out it won't come on, it can always be sent back to the manufacturer or taken to a local authorized rep and be fixed. Good luck and be thankful it was not juice or soda.....

Posted on May 30, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,847 Answers

Do not restart your laptop until it is completely dried up. it will bootup if it is completly dried up.

Posted on May 30, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to take apart canon pixma 432. Spilled soda in it, need to clean inside.


Hi Daniel,
Let me say, up front, that I am not a printer guru. My background is in biomedical electronics, but this procedure works in most applications. Take distilled water and pour a small amount into the area where the soda was spilled. Wait a few minutes to allow the water to dissolve the dried soda. Then pour in more distilled water to flush out the residual soda. Allow to dry. The water should rinse out the soda, and when it dries it will leave no contaminates of its own. This procedure works well on medical devices such as telemetry transmitters and cell phones that have been spilled on. I hope this helps. Thanks for asking Fixya. Dan

Dec 04, 2014 | Office Equipment & Supplies

1 Answer

My Keurig B40 has three different size cup sizes available, but it dispenses the same amount of water for the medium size cup and the large cup of coffee. It's barely been used so It doesn&am


I realize you think it does not need descaling to to it 'not being used much.'
However you may have hard water and I would think descaling is definitely worth a try. There might be scale built up on the water level probes in you machine.

Descaling Details are listed below:

Brewer Model: Elite B40 ' Classic B44
Special Edition B60 ' Platinum B70

To begin, you will need the following:
• 48 ounces of undiluted white vinegar
• Large ceramic mug (do not use a paper cup)
• Access to an empty sink

PREPARE
Step 1:
Empty the water in the Water Reservoir.

Step 2:
Disable "Auto Off features."

FILL AND CLEAN
Step 1:
Pour approximately 48 ounces of the vinegar into the Water Reservoir.

Step 2:
Place a large mug on the Drip Tray Plate and run a brew cycle.

(DO NOT USE A K-CUP)

Just press the BREW Button. Pour the contents of the large mug into the sink.

Step 3:
Repeat the brew process without a K-Cup until "ADD WATER"
is indicated.

Step 4:
Now let the Brewer stand for at least 4 hours while still on.

Step 5:
Discard any residual vinegar and rinse the Water Reservoir thoroughly.

RINSE
Step 1:
Ensure the Water Reservoir is filled with fresh water.

Step 2:
Place a large mug on the Drip Tray Plate and water brew cycle. Pour the contents of the large mug into the sink.

Step 3:
Repeat brew process until "ADD WATER is indicated.

Step 4:
You may need to perform additional water brew cycles if you notice any residual taste.

Nov 20, 2014 | Keurig B40 Coffee Maker

1 Answer

I work at Walmart, I had to use some degreaser to


A very small amount of degreaser spilled in a large commercial fryer is harmless, but if in doubt, discard the grease, thoroughly rinse the vat with clean water, and allow to drain completely before refilling with grease. Recycle used grease. do not pour down a drain or storm sewer.

Sep 18, 2014 | Kitchen Appliances - Others

1 Answer

Maytag neptune frontloading washer overflow


If you cannot clear the line, you will need to replace it. Here is the line to order.

Nov 22, 2012 | Washing Machines

1 Answer

My 1985 grand Marquis won't start I can pour gas


Take the gas filter off. Should be located near the front of the carbeurator, take off the air cleaner and look for it, it takes 2 wrenches to take it off, a little gas may spill out but not much and replace it, however there is a strong possibility that he gas pump is out if the filter is fine. Hope this helps

Jul 11, 2012 | Cars & Trucks

2 Answers

Water collecting in drivers door of 2008 dodge grand caravan, in lower front corner of door is tape over a drain, I pulled the tape back and about 1/2 gallon poured out. is this normal? I assume that since...


It's not unusual for water to make its way into a door, that's why the drain is there. It gets in around the joints between the windows and the door. I'm not sure why someone would tape over the drain but with the tape removed you should be okay. I'm a little concerned about the amount of water you got out so monitor the door for a while. If there continues to be a large amount of water collecting or draining, there may be a problem with the seals around the windows. Hope this helps.

Jun 18, 2011 | 2008 Dodge Grand Caravan

1 Answer

After a heavy down pour I noticed a large amount of water dripping from behind the glove box. Do I have a clogged drain?


The two drain holes in the compartment beneath the wipers are plugged with debris. Take off wipers.
2. Take of plastic panel under wipers. 3. Clear crud away from drain holes. Pour water in there afterward to make sure it drains properly..You will see it come out the bottom under the car.
4. Clean out any other leaves hope this will hlp you

Sep 22, 2010 | 1999 Dodge Grand Caravan

2 Answers

Keeps spilling over during brewing


These tanks can't actually be overfilled since all water poured in displaces the exact same amount of water coming out the spout. So, whatever amount of water you pour in, will be the same amount of water that flows to your pot minus the amount absorbed by the coffee grounds and filter.

Your problems sounds like an undersized (Non Bunn) filter, or clogged brew basket. To verify this, try pouring in only half the water for your brew cycle and wait for it to finish dripping, then pour in the rest. If no overflow has occurred, you simply have the wrong type of filter. If overflow begins again, you have a clogged brew basket, since no Bunn can flow too fast for the brew basket to keep up with it.

This is because Bunn filters are manufactured differently than generic store bought paper filters. They will flow faster, brew cleaner and stand up better than normal generic filters.
Remember, Bunn makes their OWN filters for good reason.
They made the first, best paper filters for drip coffee pots, and all others are just generic dioxin gas producing paper.

Mar 05, 2010 | Bunn VPR Coffee Maker

1 Answer

Water large amounts on floor of shut off machine


To sufficiently inspect your washer to determine where to leak may be coming from, please review the following link:

http://www.fixya.com/support/r3576656-washer_leak__front_loader

If there is a huge gush of water coming from the washer as soon as you begin the fill cycle, this is commonly caused by a small air hose on the side of the washer drum that connects to the pressure switch. If this air hose comes loose,the water will pour from the wash tub as it begins to fill. This is an easy fix, if that is the only problem.

Another cause, can be a water inlet valve that is leaking by, or a pressure switch that does not keep the water supply shut off when not in use. This will cause the tub to fill up and spill over. The following link explains how to check for this as well:

http://www.fixya.com/support/r3753262-front_load_washer_fills_when_not_in_use


Read through the information provided and let me know if you are having problems determining the cause of your problem. Please post back with your MODEL NUMBER so that I may be able to accurately determine how your washer is configured. I hope you find this information helpful.

Mar 01, 2010 | Kenmore 44102 Front Load Washer

Not finding what you are looking for?
HP Pavilion dv1000 Notebook Logo

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Computers & Internet Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18381 Answers

Tony

Level 3 Expert

2598 Answers

Are you a HP Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...