I have a corningware dish that my aunt put a detachable handle on and I can't figure out how to remove it, please help

Only place I've found is here: CorningWare Browner Instructions

As these dishes were designed by Corning for a 650 watt over, you can recalculate preheat and cooking times for your oven with the following formula:

650/(your oven's wattage) x (listed preheat time or cook time)

For example, for a Corning MW-9 dish, they list 4 minutes maximum preheat time. I have a 1,580 watt oven. So 650/1580 = .41 x 4 minutes = 1.64 minutes and about a minute and a half preheat. (MAX).

No, it states on the user instruction manual that it's for microwave use only, "Do Not Use In Oven".

Click the link below:

Corningware coffee pot

Be CAREFULL they were recalled. See the information at the site below.

Corningware coffee pot recall

Good Luck.

Zeppelinx12

TRy looking up corningware.com and see if they stock them.
Hope that gets you your covers.

We have the service manuals for these models and have uploaded them here and here to help you.

Normally you have to separate the door panels (as shown in the attached photo) and then you'll see the screws you need to remove.

Or you can watch a YouTube video (not a video I made) here that demonstrates how it's done.

You can find handy exploded views and order parts by model number here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

The in side door panel ( at total pain) must come off

If the damage to the bottom is not too bad.
On mine I took the cover for the handle loose from the bottom ( it pops off, but be careful).
and put screws at the bottom

On MOST microwave ovens, you just have to remove the inner door panel that goes around the perimeter of the glass. The following link explains how to replace the door handle:

http://www.fixya.com/support/r3696942-microwave_oven_door_handle_replacement

If you have any questions, please post back and let me know. I hope this helps you.

I HAVE A GE PROFILE SPACESAVER 2.0 OVER THE RANGE MICRO WAVE, CRACKED HANDLE, WOULD LIKE TO KNOW HOW TO REMOVE HANDLE AND INSTALL NEW ONE.

Normally You have to separate the door panels (as shown in the attached photo) and then you'll see the previously hidden screws you need to remove.

Or you can watch a YouTube video (not a video I made) that demonstrates how it's done.

In some cases, you remove one screw, then gently rotate the handle to unlock & detach it.

You can find helpful exploded view diagrams and order any needed parts at the Sears parts site.

A full Sears/Kenmore model number has 3 digits, a dot, then 8 more digits, such as ###.########

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

You can visit http://www3.sears.com/ (the 3 is correct) You will need to enter your full model number (not just 61709) and you can see expolded view diagrams which can be very helpful. Chances are the panels separate as shown in the photo I have attached below. Panel replacement can usually be done without removing the door from the microwave. In cases where it is felt that door removal is necessary, I recommend detaching the door from the hinges. I generally do not advise removing the hinges from the microwave. Whenever the hinges are removed, great care must be taken to put them back in the very same position they were in. Failure to do so can cause microwave leakage, which can cause risk of skin burns, fire, and disruption nearby electronic devices.