Question about Canon PowerShot A510 Digital Camera

1 Answer

Camera keeps forgetting the date.

Each time the camera is turned on, have to set the date.
Any ideas?

Posted by on

  • danciu-2pl Oct 13, 2008

    CAMERA HAVE ALWAYS THE SAME SCREEN TO ADJUST DATE AND TIME, BUT I CAN`T DO IT BUTTONS ARE NOT WORKING - I DON`T KNOW WHAT TO DO ?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

This can be because the camera system battery usually a CR2030 needs replacement. Check in the manual where it is located

Posted on May 29, 2008

1 Suggested Answer

edz_g
  • 67 Answers

SOURCE: Camera keeps loosing the time and date settings.

have you check the settings for time and date have you saved it? You can also try to remove the cam battry for 2 mins. then put it back in then turn on the camera and then after few secs. turn it off, then see if the issue persist.

Posted on Feb 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My wife is complaining that every time she turns off/on the camera she has to reset the data/time. I understand that when the batteries are changed the settings may be lost, but not simply when the camera...


Sounds to me that there may be another battery inside the camera that is going bad.


Issue: Everytime I power on the camera the Date / Time needs to be set.
Solution: Replacing the Date Battery for the PowerShot A480.

Replacing the Date Battery. If the Date/Time menu appears when the camera power is turned on, the date battery charge is low and the date and time settings have been lost. Please purchase a lithium coin battery (CR1220) and replace it as follows.
Please note that the first date battery may appear to expire relatively quickly after you purchase the camera. This is because it is installed in the camera at the point of manufacture, not when you make the purchase. caution.gifBe particularly careful to keep the date batteries out of the reach of children. Seek medical assistance immediately if a child swallows a battery since corrosive battery fluids can damage the stomach or intestinal walls. 1. Confirm that the camera power is turned off.
2. Open up the battery door / cover and remove the AA Batteries.
3. Remove the date/time battery holder.
4. Grasp the battery and slide it in the direction of the arrow.
a480backupbatt.jpg 5. Insert a new battery with the (+) side facing up.
6. Replace the battery holder and battery cover.
7. When the Date/Time menu appears set the date and time.
note.gif After purchasing the camera and turning on the power for the first time, although the Date/Time menu will appear, you do not need to replace the date battery. If you ever dispose of your camera, first remove the date battery for recycling according to the recycling system of your area.

Dec 31, 2010 | Canon PowerShot A480 Digital Camera

2 Answers

Camera keeps loosing the time and date settings. When turning the camera on the lens does not open, then a screen asking to set the date and time settings appears - once date reset the camera works...


have you check the settings for time and date have you saved it? You can also try to remove the cam battry for 2 mins. then put it back in then turn on the camera and then after few secs. turn it off, then see if the issue persist.

Feb 21, 2010 | Sony Cyber-shot DSC-W170 Digital Camera

1 Answer

Polaroid a520 will not keep the date


You may want to set the factory defaults by going into the main maenu.

Nov 22, 2009 | Polaroid a520M Digital Camera

1 Answer

Canon A470 The date and time menu keeps popping up every time I switch on the camera despite setting the date and time.


There is another battery next the the AA battery under a little cover marked CR1220. That is the battery size. If that battery is dead, or has never been installed then every time you change the AA batteries the camera will forget the time and date. Try to get one from a specialty store that turns over its inventory quickly and you may find that you will only change this battery every 2 or 3 years.

Oct 31, 2009 | Canon PowerShot A470 Digital Camera

2 Answers

Sony DSC-W150 power on keeps going to set date/time


The date and time settings are displayed after turning on the camera. Solution
sp.gif sp.gif It is normal for the camera to lose time and date settings if the internal battery is left uncharged for an extended period of time; some cameras will default to the time-setting screen when turned on if this happens. Follow the steps below to resolve this issue.
  1. Turn off the camera.
  2. Do one of the following:
    • Insert a fully-charged battery pack into the camera.
    • If the camera is supplied with an AC power adapter, plug the adapter into a working electrical outlet and then connect it to the camera.
  3. Allow the internal battery that retains the time and date information to charge for at least 90 minutes.
  4. After enough time has elapsed to sufficiently charge the internal battery, turn on the camera.
  5. Set the time and date.
  6. Turn off the camera for 30 seconds.
  7. Turn on the camera again.
  8. Check to see if the date and time have been saved.
The troubleshooting steps listed above should resolve your issue. If you have completed all of the steps and the issue is not resolved, service may be required. The Sony® eService Web site at http://eservice.sony.com/ can assist you in obtaining service from a Sony Service Center or locating a Sony Authorized Servicer.

Dec 23, 2008 | Sony Cyber-shot DSC-W100 Digital Camera

1 Answer

Set date and time comes up every time i turn on camera


Try resetting your camera. In picture taking mode press menu. Go to setup, go up to reset, press right arrow, make sure reset is highlighted and press set.

Then TAKE OUT MEMORY CARD. Go back into menu, go to setup, go up to format, press right arrow and highlight format, press set. Input ur date and time again and then power off and back on. If that doesn't help then you have to send into repairs. 800-706-2534 and keep choosing option 2 and they will tell you where to send it.

Feb 11, 2008 | Casio EXILIM ZOOM EX-Z60 Digital Camera

1 Answer

Cannot turn date stamp off and date keeps resetting


Try removing battery from camera then wait 10 seconds before installing. This action resets camera.

If no work, locate your camera software version. Procedure should be in manual, else could probably find it in a google search. Then locate latest version with a google search, or panasonic camera website, or call to customer service and ask.

It you do not have latest version, ask customer service how to download it.

Jan 20, 2008 | Panasonic Lumix DMC-TZ3 Digital Camera

5 Answers

Camera keeps resetting the settings when turned off


Possible solution?

PROCEDURE
1. Initialize the system.
a) Enter the TEST mode.
b) Select "3:ROM UPDATE" and press SET button.
c) Next, select "5:SYSTEM INITIAL" and press SET button.
d) The following message appears.
SYSTEM INITIALIZE
START ...
PUSH OK KEY?
e) Press SET button and System is initialized.
"SUCCESS !" appears on the monitor.
2. Write firmware.
Update the firmware version"
Write the firmware.
If the TEST mode boots automatically, change "USB TCC ON" to "USB TCC OFF".

Nov 06, 2007 | Casio EXILIM Card EX-S770 Digital Camera

3 Answers

Date time setting does not program


There is not an option to remember the date/time when you power off the camera. The camera should always remember the time. If it forgets the setting when you power it off then your backup battery has gone dead. Check your manual to see if it is something you can replace yourself. I am not familiar with this camera specifically but some cameras make the backup battery accessible and some require disassembly. David Millier Advance Camera Repair

Feb 22, 2007 | Casio EXILIM ZOOM EX-Z600 Digital Camera

Not finding what you are looking for?
Canon PowerShot A510 Digital Camera Logo

Related Topics:

653 people viewed this question

Ask a Question

Usually answered in minutes!

Top Canon Digital Cameras Experts

Doberman

Level 2 Expert

246 Answers

Tony

Level 3 Expert

2598 Answers

halotheracer
halotheracer

Level 2 Expert

68 Answers

Are you a Canon Digital Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...