Question about Samsung Projection Televisions

1 Answer

DLP TV picture will not come on. Also, TV will turn itself off after a couple off minutes of trying to start up.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 317 Answers

Badd lamp

Posted on May 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my DLP TV turn itself off


Try replacing that lamp door switch, this has been known to cause issues in some Samsung DLPs

Contact Samsung at 1-800-627-4368 for proper part#

Oct 21, 2014 | Samsung HLP5063WX/XAA

1 Answer

My Mitsubishi WD-65638 turns on then flickers and turns off?


Flickering must be due to the fault to lamp itself. If you wish to get more details, check this link.

Mar 03, 2013 | Mitsubishi WD-65638 65" DLP HDTV

1 Answer

Zenith z56dc1d dlp tv picture works for about 1 minute then starts shaking and tv shuts off


You may want to get it in a rather warm room and or remove rear cover and use a hairdryer to warm everything up inside the Cabinet--with rear cover off look to see if the fans are dirty etc and if they all come on, if a DLP especially look at the lamp itself and the fan that cools it.

Dec 18, 2012 | Zenith Projection Televisions

1 Answer

Can anyone point me in the right direction?I have had my samsung DLP (model SP50L6HD) for 4 years. This morning my children were watching TV and the tv started turning itself on and off. I switched it...


It could be the temp sensor going bad. This sensor sits on top of the metal housing which the bulb assembly slides into. The bulb assembly will have a hole on top and this is where the sensor is above. There is a small blue and white wire that plugs into it. If you pull the wire out and put a paper clip or wire in the coupling you will basically bypass the sensor connecting the blue and white wire. If your tv turns on then that is your problem. Its cheap too. Here were my symptoms..1] Turn tv on 2] Bulb would light up..(which eliminates the ballast) regular picture would show up (which eliminates the bulb and color wheel) 3] 30 seconds later tv would shut down with 3 flashing lights. After bypass the tv turned on as always and hasnt shut down yet. Always un plug tv first. Get the replacement part to avoid overheating and possible fire

Jul 24, 2011 | Samsung HLM507W 50" Rear Projection HDTV

1 Answer

LG DLP Suspected Faulty Bulb... how to be sure?


First pull back off turn TV on watch Fan behind lamp more then likely it is going bad Fixed LG 9months ago and it was the Fan.If Fan Stops turning Lamp will not light.

Aug 06, 2009 | LG Projection Televisions

2 Answers

My 50 Viore dlp tv turns itself off after just a


HI, this may be a simple cooling issue. try inspecting the cooling fans that are located near the power sector. if these cooling devices are not operational, they will cause the power board to shut down periodically, due to heat build up.

If the fans are operational, this will confirm a weak and defective power power board.

Jul 20, 2009 | Projection Televisions

1 Answer

TV shuts itself off after a couple minutes of being on.


One must be very careful of the quality of the replacement lamp. Many of the cheap 'deals' on the web for replacement lamps are substandard. I always recommend that replacement bulbs be the original manufacturers bulb.

Apr 30, 2009 | Mitsubishi WD-73827 73" HDTV DLP TV

2 Answers

Samsung DLP 62 inch turns off by itself after being switched on


take off the lamp access door on the back and find the safety switch that the door pushes on. unplug the connector from the switch and put staple into the connector to short out the cable. Switch is probably bad. worked for me. same problem.

Apr 07, 2009 | Samsung 61" Slim-Depth DLP HDTV

1 Answer

Samsung DLP TV, no picture, has sound


Try replacing the ballast next. Its the small circuit board directly underneath the lamp housing. You can access it through the lamp door. If the ballast is overheating or has a leaking capacitor, the tv won't stay lit for more than a minute or two.

Mar 12, 2009 | Samsung HL-P5063W 50" Rear Projection HDTV

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Projection Televisions Experts

The Wyzzyrd

Level 2 Expert

83 Answers

Donald Griswold
Donald Griswold

Level 1 Expert

8 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

Are you a Samsung Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...