Question about Patton Electric Dryers

1 Answer

FAN MODEL# 1010 MP

MY FAN WILL CUT OFF AFTER RUNNING FOR ABOUT A HOUR, THEN IT WILL COME BACK ON IN ABOUT 15 MIN.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 254 Answers

Hello

This would seem to be the motor heating up and cutting out on a thermal overload. Check to see if the motor area is clean and that the fan blades are clean. To clean the motor you can blow compressed air through it. To clean the blades disassemble the cover remove the blade and clean with a mild soapy solution.

Posted on Jun 03, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

Blade for Patton Stand Fan Model 1010-MP1


u can get a replace blade from hard wares and fan shops also try ebay and oztion

Sep 09, 2008 | Patton (HASF1016UC) Stand (Pedestal) Fan

1 Answer

After 15-20 min both light start blinking


Make sure you're using the correct wattage. Also, you can check the fuse.

Oct 25, 2014 | Monte Carlo Dryers

2 Answers

My fan just stoped it was running now does't work at all


did you check the power,check the cord to see if cut or a nick in cord,check breaker, see if motor was hot to touch,did you plug in to a 220,might need to take motor a part to see if any wires were burnt or discolored,good luc

Aug 11, 2011 | Holmes Products Dryers

1 Answer

Ceiling fan capacitor hook up problem. I have a 3 speed fan. 4 switch. A 3 wire capacitor - CBB61. Kids lost wiring diagram. Any which way I try to wire it up only one of the speeds works. Any wiring...


The reverse switch on my Hampton Bay ceiling fan didn't work. I cut the 6 wires; 1 white, 1 gray, 2 pink, 2 yellow. Here's what I did. Removed reverse switch. Had 6 wires white, gray, 2 yellow, 2 pink. Connected gray to yellow, connected white to pink and fan runs fine. Is this OK? I do not need to reverse fan. It's been running for 1 hour now with no problems. Don S.

May 15, 2010 | Dryers

1 Answer

Squeaky noise from the motorafter running for


I would unplug the fan and clean off the motor shaft behind the fan and vaccum the motor housing and around the motor ends.

Once you've got as much dust and grime as possible removed, use some 3-in-1 oil and LIGHTLY oil each end of the motor shaft (behind the fan and next to the motor housing) and if possible, at the other end of the motor housing.

Make sure the fan is UNPLUGGED when you do this!!! Give the fan a slow spin by hand and hold upright to allow the oil to seep down the shaft into the bearings.

I usually do this once or twice a year on my portable fans and unless the bearing isn't completely worn out, it usually helps the fan spin more easily and keeps it running very well.

Hope you find this very helpful and best regards!

Aug 06, 2009 | Marvin W.B. 81400 14" HIGH VELOCITY FLOOR...

1 Answer

The furnace won't stop at the programmed temperature set ponts


this is called a swing tempature it is desined to improve the eficincey of the frnace because it take less energy to run an hour in a three hours then 3 bursts of 25 min in a three hour period

HOWEVER if you do not like this you can usualy set the swing temp

Jan 16, 2009 | Hunter Fan Company 5/1/1 Programmable...

Not finding what you are looking for?
Dryers Logo

Related Topics:

893 people viewed this question

Ask a Question

Usually answered in minutes!

Top Patton Electric Dryers Experts

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

yadayada
yadayada

Level 3 Expert

64034 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Patton Electric Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...