How door gasket goes on/ works - Whirlpool Duet GHW9150P Front Load Washer

It sounds like you are fixing the wrong area. If water is coming down between the inner and outer door panel and following the wiring harness, the leak is inside the door. Either from the soap cup mounting or the rinse agent area which I think is the same unit on your model. There is a gasket behind that part. Also check the inner door if its plastic for any possible cracks.

Hello;

My name is Peter. I am a retired field service refrigeration technician.

There are several things to check:

1.) Door Gasket -Take a piece of paper. With the freezer door closed run the paper around the gasket. If you can do that, then you are not getting a good seal.
Repair: Clean the freezer door gasket with soap and water. While still wet, take a hair dryer and a spatula, going around the gasket, heat the gasket while pulling the gasket out to expand it.
Note: This only solves the problem if there is frost in the front area of your freezer.

2.) Freezer fan not working - In some cases, The freezer fan helps to prevent warm air from getting into the freezer.

3.) Food Storage - Make sure you do not overload the freezer, and that the food product is inside the bounds of the racks.

4.) Fresh Food Section Air Vent Wide Open - This is your probable cause: Heat goes to Cold like a magnet. When you open your fresh food section door and then close it you are forcing warm air up the vent that goes to the freezer. You probably have a broken air vent assembly.

Most likely the thermistor inside the compressor is shutting the unit off to keep it from burning out. No fridge should run for that long no matter how cold you want it to be inside. If all the door gaskets are sealing properly your most likely problem is the thermostat is bad and not sensing the temp, thus the unit keeps running.If your doors are not closing properly (alignment or gaskets) same issue will occur. Check alignment and gaskets using dollar bill. Close bill between door frame and gasket, pull bill out slowly should feel resistance, if not door is crooked or gasket needs adjournment or door gasket is bad.Do this on all doors all the way around to locate problem areas.

There is a spring that goes all the way around the door, just under the edge of the gasket. If you remove that spring starting at the bottom of the door, you should be able to remove the gasket for replacement

it goes on the groove in the gasket at the door , the side view of the gasket would be a V, it goes right in the middle. make sure the gasket is first snug on the metal frame groove. the spring is very tight, start at top then work down, use a flat screwdriver to pry it in at bottom. it may help to wet the gasket

Open the door and reinstall the bellows (door gasket) onto the door lip. The metal ring clamps the bellows to the door lip. Start in the groove at the top and work your way down the sides. The spring part goes on the bottom (be careful not to stretch it too much). An extra pair of hands could help.
Let me know if you need more assistance.
Good luck!

Hi have you adjusted the door striker on the top part of the dishwasher? This is the part that the main door latches onto and can be adjusted in or out!

to remove door there are screws at top door hinge, them and door should lift right off. fold back gasket and you will find a lot of screws under gasket remove them and inner door panel should lift off exposing hoses .

Contact the Manufacturer ASAP