Question about Hitachi 51F510 51" Rear Projection HDTV-Ready Television

1 Answer

New screen My screen was smashed last christmas. I managed to remove the 3 screens but now where can I get new one's?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 146 Answers

Call Union Electronics at 800-648-6657 ext. 4911
They will need your make and model number of the tv.

Posted on Nov 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Samsung led 1080p from 2009 it's been in


You have a bad LCD/LED panel if they are pin stripes or look like they originate from a 'bullseye' looking point (screen was smashed.) A new panel is likely more cost than a new TV.

Oct 06, 2014 | Projection Televisions

1 Answer

Toshiba 46h84


remove the front face u will find the screens start with the one that its inside face is facing the back cover then next and the last as u replace u will have to match the last removed screen and replace it as the first then the 2nd and lastly the one u removed first n there u have it as originallly fitted

Jul 14, 2013 | Toshiba 46H84 46" Rear Projection...

1 Answer

My hand went in and smashed the screen on my toshiba need new screen


pigdigger,

I have bad news for you, the total cost for the three screens you will need will be about $290.00. They can be obtained from http://www.encompass.com . Here are the part #s: Fresnel 23311898 $80.00, Lenticular 23311897 $120.00 and Protector 23311863 $90.00.

Installation is straight forward. Generally you have to remove the back top cover with the mirror attached. Then check under the bezel on the front, below the screen, for several screws. Remove the screen and lay it flat on the floor. Remove the screen hold in screws or clips. Remove the screen.

Assemble the new screens. Make sure they are in the correct order. Protector (on outside), Lenticular in the middle and the Fresnel on the inside. You will need to secure the screens together. Black cloth tape works well around the perimeter. Reinstall the screen into the frame and reassemble the unit. This should complete the job.

Thanks for using FixYa and for the great rating.

hardrocko

Sep 29, 2010 | Toshiba 42H81 42" Rear Projection...

1 Answer

Was watching my vizio and i heard a pop and the screen went blank, but there still is sound, its about 4 years old can it be fixed and ballpark on how much it would cost to fix!


Main Power Supply issue! The repair would cost you more than what a new flat panel would cost you. Vizio is a Chinese made TV. Only lasting 3.5 to 4 years. Go out and buy yourself a new Christmas gift a new flat screen TV. Try to get a name brand one like Sony, Samsung or Panasonic. They have great service records. Vizio is your typical breaks, throw it away.
Blessings always,
A/V Media Tech Guy

Nov 28, 2009 | Projection Televisions

1 Answer

Screen smashed


Without the make and model of the unit in question, we can't help much. If you could provide that info, we can get you that information. Thanks, Dan

Jun 12, 2009 | Samsung Projection Televisions

2 Answers

TP50H50 Screen Broken


The Toshiba part number is: 23837513

But it is listed as no longer available .. all you can do is call parts dealers to locate

Jan 05, 2009 | Toshiba TP50H50 50" Rear Projection...

1 Answer

Screen replacement


I too am trying to fix this. I got the replacement part and I can't figure out how to repair the screen

Jun 09, 2008 | Hitachi 65F59A Television

1 Answer

Tint on television stays a greenish color.


Tubes are probably dirty. Very expensive fix. Unless it has a warranty or is recently new, look for a local cheap one or one with a smashed screen of the same size. Easy to change the screens out and is very cost effective.

May 14, 2008 | Hitachi 50UX57B 50" Rear Projection...

2 Answers

Need to replace a cracked screen


WD-57731 & WD-65731 Front Disassembly
57” & 65” Models Screen Frame
Removal
1) Pull off the Speaker Grill.
2) Remove all the screws (b) from the
upper rear cover (except one at an
upper corner to support the frame).
3) Remove 10 screws (a) from the
front of the screen frame.
4) Remove the remaining ***** (b)
(supporting the frame). Carefully
pull the Screen Frame from the TV
and disconnect the ES and LE
connectors.
57” & 65” Models Screens Removal from Frame
1) From the rear of the Screen Frame remove 20 screws (a) from the top and bottom rails
2) Remove 6 screws (b) from each side rail.
3) Carefully lift the Screen assembly from the Frame.


MODEL: WD-52631 / WD-57731 / WD-65731
Screen Replacement
CAUTION: Wear gloves when handling the Lenticular Screen and Fresnel Lens.
This prevents cuts and finger prints. Do not place Fresnel Lens in the sun.
This may cause fire and heat related injuries.
Lenticular Screen and Fresnel Lens Replacement
1) Apply LENS-TAPE along the rear top edge of the Lenticular Screen.
2) Place the Fresnel Lens on top of the Lenticular Screen, and apply pressure along the top edge.
3) Place the screens in the screen frame and reinstall the cushions, top, bottom and side rails.
NOTE: The Lenticular Screen label must face the front and the Fresnel Lens label face the rear.
4) Reverse the Screen Removal Procedure and insert the screens in the Bezel.
Lenticular Screen and Fresnel Lens Removal
1) Remove the top, bottom and side HOLDER-SCREEN rails and their cushions from the Screen Frame.
2) Lift the screens as a single unit from the frame.
2. Separate the Lenticular Screen and Fresnel Lens.
Note: When separating the Lenticular Screen from the Fresnel Lens, use caution
while prying the Screen and Lens apart. Use a slot type ***** driver, and
remove the pressure sensitive double sided tape.

Mar 11, 2008 | Mitsubishi WD-65731 65" HDTV

2 Answers

Need to disassemble Mitsubishi VS-6041 60 in Rear Projection


Wow, You are asking for a complete disasemmbly. If this is necessary, you have to remove any screws you can find that are connected to the front panel. Usually they are in the top of the set ( you'll find them after removing the mirror panel and mirror ). I wouldn't remove any tubes as the tube convergence would have to be all reset and that would require a cross hair generator. I do hope this has helped in some way, but all I can do is send you my best wishes as I certainaly don't suggest disassembly if there is any other way. Good luck
Ed
NC Electronic
Mills, Wyoming

Nov 24, 2007 | Mitsubishi VS-6041 60" Rear Projection...

Not finding what you are looking for?
Hitachi 51F510 51" Rear Projection HDTV-Ready Television Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hitachi Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Hitachi Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...