The bolt on the bottom of the refrigerator door keeps falling out causing the door to fall off.

Did you clean the surfaces thoroughly and glue it down with white or clear silicone, then leave it to cure? also was it an OEM replacement or an Amazon special as the quality is different.

visual it has to be going somewhere

Samsung washer recall Fridge is doing everything you described including dropping silver ? balls on the floor And the dryer belt on Samsung dryer broke after 3 years Samsung household products HORRID

The bolts that hold the motor for window loosen up and fall out .but before it falls completely out it will gouge out the door frame find the bolts in the bottom add a washer lock tight the bolt and tighten them back in easier to do 1 at a time this happens on all doors

There are 3 bolts that hold the bottom of the freezer door in place, if you remove them the door will fall to the floor then youmcan pull it off then you can access the drawer

At the bottom of the door , there is usually a steel piece which keeps the door from opening too far . Sometimes this piece gets bent or the screw holding part of it falls out , letting it move with the door . You should check the bottom of the freezer door and compare the angle and movement to the refrig door . Also , the adjustment for the door could be too hight , causing it to miss the door stop .

You don't say what kind of refrigerator you have, so this will be a generic answer. You need to replace the door closing cams, which are located at the bottom hinges.

The cams provide a sloping surface or v-shaped notch to lift the door slightly as you open it. The cam's sloping surface causes the door's own weight to hold it closed. If the cam has broken, it can fall out or turn with the door, allowing the door to come open.

The magnetic gasket is only supposed to ensure a good seal, not hold the door closed. You don't need to replace it.

Its not hard at all,Just losen all the bolts an the door would well, fall of :)

Just check if the fridge dit not get hurt or the door,other wize go for it....

Good luck.

There is a recall on Viking refrigerator hinges. Check and see if your refrigerator falls under this recall. It may just require a new hinge. The recall hotline # is 888-345-2650.

You call also see if it falls in this category.
VCSB483, DDSB483, DFSB483, DTSB483 Date codes before 030104 (on serial # ). Go to this site to see if you fall under the recall.

http://www.cpsc.gov/cpscpub/prerel/prhtml09/09242.html

usually due to rust or crud build-up. try lubricating moving parts with WD-40, or possibly removing accessible screws/bolts and manually cleaning it up.