How do I set a casio digital-analog watch, model aq-160?

Analog time follows digital time.
For manual,check the link below using the module nbr (4 digit nbr in a frame on the back cover).

Timepieces Watches Manuals CASIO

here > http://ftp.casio.co.jp/pub/world_manual/wat/en/qw5208.pdf is the manual.

Go to "setup" pushing mode sometimes then right down push should move analog clock

you can get
instructions from the Casio web site.

Go to the casio web site "casio.com".

Select "support" and the "manuals",
watches;

Accept terms

Select "watch manual archive"

Read the number of the back of your watch and enter it into the search box

You can get instructions from the Casio web site.

Go to the casio web site "casio.com".

Select "support" and the "manuals", watches;

Accept terms

Select "watch manual archive"

Read the number of the back of your watch and enter it into the search box

Click on "search" and the download your instructions.

I had exactly the same problem with exactly the same model watch, and it happened to me twice. The AQ-160 is the important part of the model number as far as replacement parts are concerned. The first time, I took it to the shop where I bought the watch, and they replaced the band, but it cost me $50. The second time, I looked up the Web for the master agent for Casio in Australia, and they said I could buy the end piece, not the whole band, for $6. I found I could replace it quite easily myself by using a drawing pin to remove the spring pin that holds it together. A bit fiddly to reassemble but not too bad. In fact, I didn't wait for the new part to arrive, just used the unbroken end of the old band. So now I have a repaired band plus the old band and a new end piece, in case it ever happens again.

I really like this watch, but it is a pity the bands are so weak.

You can find the instructions at this web site http://www.casio-europe.com/euro/watch/collection/aq-230ga-9dmqyes/ :)

In timekeeping mode press bottom left button 6x to enter setting mode.
Then hold down top left button until digital time flashes, which indicates your in analog time setting mode. press bottom right button to set the time.
If you hold down bottom right, it will set time at a faster speed.
Hope this helps

Keep pressing 'select mode' button until you get to H-SET. Than hold 'adjust' button until screen starts to blink. Now you can adjust analog clock by pressing 'start/stop (search)' button. When you are finished, just press 'adjust' button once. That's all.

The Casio web site has all manula on line. The model no is 3352

Good luck