My pc won't pick up my cam...i

It could be the fuel system.
It could either flooding or starving for fuel.
If injectors are fouled badly it will wet the plugs and not fire.
If plugs are pitted that makes it easier to flood. (check plug tip condition, check all plug wires and boots are good)

If it is starving -- fuel pump weak (going to fail).
Need to test fuel pump pressure.

change the ignition pick up coil assembly normally located on the distributor under the rotor on the bottom of the distributor or just replace the distributor

First, check the condition and operation of the following:

1) Spark plugs, leads and coil(s)
2) Air filter
3) Fuel filter and pump operation.

it's probably the driver
the driver might be not installed,if your operating system is windows xp,then you need to install the driver,but windows 7 usually doesn't need any driver,but still i recommend you to install the driver
if you don't know where you can find the driver,just tell me what series is your webcam is,and i'll find it for you ^^

Check your pick-up sensor located inside the timing cover,behind the adjustor plate. If the filament is not intact you will have no spark.
A defective coil, cam position sensor, or stator will also cause a no spark condition.

Good luck, i hope this will FixYa and get your bike back on the road.

Apart from obvious things like it not being plugged in, it could be that the chatsite you;re using hasnpt been set up for the cam.

Try going into audio / video settings for the site in question and selecting the cam from the drop down. It will recognise any cams you have installed on your PC.

If it doesn't find your cam, uninstall the cam drivers, restart your PC, reinstall the cam drivers ( if you're using Windows the plug and play should work, if not use the disc that came with the cam ) and then restart the PC.

Once restarted, access the site you want to use the cam on, and then select it from teh audio / video set up panel.

PLUG CAM TO PC ...TURN ON CAM found new hardward wiz comes up choose pick driver from list, choose generic on left/imaging device on right;find new drive under"my computer"double click folders and sub-folders until pics show up...enjoy
Ron L

down load split cam and install it from the site mentioned below run the software then connect your pc , open split cam from the progrrame, in split cam icon choose usb cam your cam shall work,
http://www.giveawayoftheday.com/freeware/usb/webcam-driver

thank you ,
domnickr

make sure the most recent drivers are installed

i have the same problem