Question about JVC AM FM CD DET FACE CAR STEREO

2 Answers

Jvckd-g335 change clock thanks warren - JVC AM FM CD DET FACE CAR STEREO

Posted by on

  • postman_warr Oct 03, 2010

    tried holding select button goes to demo off but dosnt change time pushed button for i minute still didnt change time waren

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,515 Answers

Hi,

You need to hold the sel button down for a little while then it will change displays that's when you use youe right seek button until you hit the Clock H to change the clock hour or Clock M to change the minutes when you hit it you use your volume control button to change the time.

Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Posted on Oct 03, 2010

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,382 Answers

Hi, you need to hold the sel button down for a little while then it will change displays, that is when you use your right seek button until you hit the Clock H to change the clock hour or Clock M to change the minutes when you hit it you use your volume control button to change the time....

Posted on Oct 03, 2010

  • 1 more comment 
  • Tunde Autos
    Tunde Autos Oct 03, 2010

    http://www.fixya.com/support/p187738-jvc...

  • Tunde Autos
    Tunde Autos Oct 03, 2010

    Hi, to get out of demo mode, hold your sel button until it takes you into your menu and use your track skip buttons till you get to DEMO and turn your volume knob to the left until it says off and then press select again to get out of your menu...



  • Tunde Autos
    Tunde Autos Oct 03, 2010

    If it helps, don't forget to accept and rate the solution...

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I CANT SET THE TIME ON MY JVCKD-G510


Hello... sorry you are having a problem with this unit. Here is the procedure to fix your problem. Press and hold the "SEL" button for approximately 2-3 seconds. You will enter the menu section. Press the seek button below the volume knob ">>>" until it reads "Clock-H". Rotate the volume knob to adjust the hour. Press the ">>>" button again and "Clock-M" should appear. Rotate the knob to adjust the minutes. Hit SEL button to exit the menu when you finish. I hope this helped!

20 year car audio/video installer
Bay manager

Mar 17, 2011 | Car Audio & Video

1 Answer

I have been having my 3.0 shaking alot when I start it up and drive but go about 200 feet and it runs nice and smooth an i got a read of po303 and changed all of my fuel injectors and still have the read...


check the compression cylinder 3or a lot if iare below of 120poundsor less to 90 the trouble is the engine uncompressed and check the spark plug . and the wire include the ignition coil too

Sep 18, 2010 | 2001 Ford Ranger Regular Cab

1 Answer

I have a eMachines T2082 Inc. L7VMM2 Main bdBoard: KM266-8235 Bus Clock: 133 megahertz BIOS: Phoenix Technologies, LTD 6.00 PG 02/23/2003 The Hard drive access led got disconnected, do you know what pins...


This is the support page for the board. Scroll to bottom of page and download the manual which contains the location of the hard disk LED pins. Thanks Mike

Nov 29, 2009 | E-Machines eMachines Desktop PC

2 Answers

Is jvc kd-g335 blue tooth compatable


If it is a "Ready for BlueTooth" model you will need this adapter JVC KS-BTA20

Jun 04, 2009 | JVC KD-G340 Car CD/ MP3 Player

2 Answers

Cannot set clock on my JVC KD-G335


You need to hold the sel button down for a little while then it will change displays thats when you use youe right seek button until you hit the Clock H to change the clock hour or Clock M to change the minutes when you hit it you use your volume control button to change the time.

Jan 04, 2009 | JVC AM FM CD DET FACE CAR STEREO

1 Answer

Resetting clcok on Microwave Oven..


I have a Magic Chef microwave oven, The model # is MCD1311ST.
After I reset the clock when daylight savings time ended, it displays 1:00 PM as 13:00, 2:00 PM as 14:00, etc. How do I get it back on a 12/12 cycle instead?

Warren.

Nov 08, 2008 | Magic Chef Microwave Ovens

1 Answer

SAVING SETTINGS


make shure you have the yellow on the back to a 12+ constant and red to a +12v switched you may have them backwards

Jul 25, 2008 | JVC Car Audio & Video

Not finding what you are looking for?
JVC AM FM CD DET FACE CAR STEREO Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top JVC Car Audio & Video Experts

Radames Pagan
Radames Pagan

Level 3 Expert

196 Answers

kakima

Level 3 Expert

102366 Answers

xxxxxx xxx

Level 3 Expert

4869 Answers

Are you a JVC Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...