Question about Bosch 18 in. SRS45E02 / SRS45E08 Exxcel Slim-Line Free-standing Dishwasher

1 Answer

My bosch exxcel dishwasher will not drain after wash cycle

After wash cycle my dishwasher will not empty, we have tried it in all cycles including cleaning so i do not think it is a blockage

Posted by on

  • brendanpatto Jan 18, 2009

    it will not finish the washing cycle and will not drain

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Bosch Master
  • 19,396 Answers

That is because the water level switch activated by the floating sensor is stuck.

You probably need to have the water level switch replaced.

You can find parts on websites below:

You can find replacement water level switch , and schematics on websites below:

BSH - Bosch Customer Service

Appliance411: Repair Parts

how to mend it .com - ~~ Wiring diagram for BOSCH Dishwasher.

Posted on Feb 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bosch SL1501B dishwasher doesn't drain water after the washing cycle. Also with new drain pump. What else could it be?


Check the following.
1. The drain hose has to be discharging at a high enough point to prevent water flowing back into the machine.
2. Make sure your drain hose is not twisted or kinked.
3 . Make sure your drain line is not blocked push a flexible hose down it to dislodge any fat/debris
4.If your drain line discharges into a shared drain with another appliance i.e. garbage disposal make sure it is not blocked.
5. You may have a blockage at the inlet to the pump which would slow down the pumping rate,
Since you mentioned the mushroom shaped float allowing the washer to empty this may be defective.
See the link attached.
Hope this helps.
Crofter

Bosch Dishwasher Does Not Drain

Apr 30, 2015 | Bosch Dishwashers

1 Answer

Cycle starts, but does not fill with water


When I start a new cycle, I first hear the pump run to empty out all remaining water, and after that I hear the motor run for the regular washing cycle, but there is no water in the dishwasher. After a few minutes, the cycle stops, and the washer claims the dishes are 'clean'. When I try starting a new cycle over and over again, about one in 20 times, the cycle will run normally with water. But then the next time, the problem starts all over again. Once a cycle starts correctly, everything works fine, including the rinsing.

Jan 11, 2013 | Bosch SHX5AL02UC Dishwasher

1 Answer

I have a Bosch Exxcel dishwasher which runs the drain pump constantly even with the door open and despite there being now water in the machine at the cycle wont start. I have checked the warer amtrix and...


I am not sure about this model but most models run a drain cycle for a set period at the start of a wash cycle and then move on to normal filling and cycle of machine provided the various switches are at the low level it will carry on to its set cycle,is the apartment or flood switch ok?

Jun 30, 2010 | Bosch 24 in. SGS47E02 Exxcel Free-standing...

1 Answer

I have the same problem with mold in the dishwasher and Bosch is much less than helpful to solve the problem. I will never buy Bosch again.


try running the unit with 1/2 cup of bleach without any dishes in the washer this shold kill the mold and once the cycle has completed there wont be any bleach in the dishwasher but run it a couple of times empty to ensure the bleach has done its job

Mar 11, 2010 | Bosch 24 in. SGS45E02 / SGS45E08 Exxcel...

1 Answer

Water left after finishing wash


I have a Bosch Dishwasher and the E-Nr is SGS4362EU/03. The machine is approximately 4 years old, in good condition and has been working very well. Suddenly, there is water remaining after it completes a 50 degrees C wash cycle. This is also evident with the pre wash cycle and the 65 degrees wash cycle.

I have checked and cleaned the filters. I have loosened the internal pump white cover (Torx T 20 screw) and checked for any physical blockage - none. I have also checked for any drainage hose kinks - none.

I have tried a series of empty washes and the machine drains the water during the wash cycles. The dishes are also have a dull colour and show show signs of not being properly rinsed during the wash cycle.

Please assist.

Reagrds,

Brian

Dec 27, 2008 | Bosch 24 in. SHY56A05 Stainless Steel...

1 Answer

Bosch Dishwasher


To find the model number I have to open the door and faintly etched into the metal surround at the top I can see the model number.

Aug 31, 2008 | Bosch 24 in. SGS45E02 / SGS45E08 Exxcel...

1 Answer

SMEG INTEGRATED DISHWASHER FLOODING


Are you saying it overfilled and flooded out, or did it empty onto the floor?

Nov 18, 2007 | Bosch 24 in. SGS45E02 / SGS45E08 Exxcel...

Not finding what you are looking for?
Bosch 18 in. SRS45E02 / SRS45E08 Exxcel Slim-Line Free-standing Dishwasher Logo

2,716 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bosch Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

prem mathew

Level 3 Expert

662 Answers

Are you a Bosch Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...