Question about Garden

Open Question

Garden light fixtures, electrical w/#E181950, 5G45 TDC power products photo timer sensor, model # DA-45-12W-1. I had installed the lights outside as instructed. They all lit up and stayed on for a few hours, then quit working. I know for a fact it isn't the outlet as I have tested everything. The photo sensor does not come on Auto, 4H, 6H or 8H. I just bought this from Lowes Home Improvement and I am not getting any support from them.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3197 Answers

SOURCE: light quit working

The light is controlled by a relay on the circuit board. The problem is there are no schematics available and individual parts are not available.

Posted on Jun 24, 2009

Ad
  • 760 Answers

SOURCE: In 2008 we bought from Lowes a husqvarna 54"

Try this linke to husqvarna http://www.husqvarna.com/us/landowner/accessories/product-accessories/tractor-accessories/triple-bagger/

This should fit, and look at the tab for where to buy. (I wouldn't want to empty all that grass)

Posted on Jul 05, 2010

  • 176 Answers

SOURCE: installation of a basic GE in-wall timer

The black and white, The red wire is the ground. Ron

Posted on Aug 11, 2010

kel1guy2002
  • 3740 Answers

SOURCE: I have a Kirkland Patio

Hi and welcome to FiXya I am Kelly.

Your pilot light burning yellow is a sign of a dirty orifice. This can be caused by insects or a spider web in the pilot air supply.
To clean the air supply / orifice area see this page:

http://www.nexgrill.net/trouble/p1.5.html

Also the thermocouple may not be close enough to the flame. You won't know this for sure until you finish cleaning the pilot / orifice area.

This link has step by step links for all of the components / causes of a pilot not staying lit. Click each of them and it will bring up a pdf file with step by step instructions and pictures:

http://www.nexgrill.net/trouble/p3.html

A bad thermocouple can also cause this. Givien you have a yellow flame I do not think this is your problem. But if it ends not staying lit after cleaning see this page on how to get to the thermocouple:
http://www.nexgrill.net/trouble/p2.2.pdf

Thanks for choosing FixYa.

Kelly



Posted on Sep 05, 2010

vetteman3002
  • 2299 Answers

SOURCE: I have a Hampton Bay

I can help you with this problem. Just need a little more info. I am a master electrician, so we should be able to get you fixed up. When you say light fixture control box are you talking about a motion detector?

Posted on Sep 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you program a da-150-12w-1?


150 Watt Transformer TDC Power DA-150-12W-1 - eBay

www.ebay.com > ... > Outdoor Lighting > Walkway & Path Lights

eBay150 Watt Transformer TDC Power DA-150-12W-1 in Home & Garden, Yard, Garden & Outdoor Living, Outdoor Lighting, Walkway & Path Lights ' eBay.

New Free SHIP TDC Power Da 150 12W 1 Low ... - eBay

www.ebay.com > ... > Outdoor Lighting > Other Outdoor Lighting

eBayNew, Free Ship, TDC Power DA-150-12W-1 Low Voltage Transformer, 12v 150watt Max in Home & Garden, Yard, Garden & Outdoor Living, Outdoor Lighting ...

[PDF]SECTION H - Etlin

www.etlin.com/pdfs/Outdoor_Transformers.pdf
1-800-661-9610 (Canada) 1-888-762-5384 (USA). OUTDOOR LOW ... DA-XX-12WSeries - 60 to 150VA Small Case Low Voltage Outdoor Transformers.

Da-150-12w-1 Manual ' downloadthingsfast.com


Dec 09, 2015 | Malibu Hardware & Accessories

1 Answer

Tdc power garden light transformer


Product is not identified.
Copy following links to identify product and download possible manual with watt rating:
http://waterheatertimer.org/Malibu-power-pack-stopped-working.html#paradise

Gene
;;;

Sep 23, 2013 | Hardware & Accessories

1 Answer

Lithonia photocell light stays on during the day


1) Buy twist-lock photo control:
http://www.intermatic.com/en/Products/Sensors/PhotoControls.aspx
http://www.amazon.com/s/ref=nb_sb_noss_1?url=search-alias%3Dtools&field-keywords=twist+lock+photo+control

2) Spray bit of WD40 on twist-lock blades before installing new photo eye, and then rotate back and forth a bit to make sure there is electrical contact.
Test by placing black tape over photo eye.

Feb 14, 2013 | Hardware & Accessories

1 Answer

Testing photo cell


These devices typically require a minute or two to change state from ON to OFF when the the threshold of light and darkness is reached. Place black electrical tape over the sensor and allow a minute for it to turn the light on. Make sure that no light shines into the sensor or that the sensor can not see light in the night time.

Lastly, double check instructions and wiring. White should be connected to BOTH the neutral incoming power AND the light fixture's white wire(s). Most times, black is 120V source, and red is the switched 120V out to the fixture.

If it isn't working, make sure the lamps are good. This photocell is suitable for use with compact fluorescent lamps, fluorescent lamps and other fixtures that use ballasts and transformers as long as they do not require more than 840 VA.

Good luck!

Dec 29, 2012 | Carlon Home Products Wired Photo Cell Post...

1 Answer

TDC low voltage transformer model DA 150 12 W reset button trips


There is a short circuit.
Copy following link to identify possible problem and download manual
http://waterheatertimer.org/Malibu-power-pack-stopped-working.html

May 02, 2012 | Hardware & Accessories

1 Answer

Malibu TDC PTST-30012 turns on in the middle of the day


1) Contact malibu lights directly.
Their site does not acknowledge TDC PTST-30012, so I cannot access a manual with best information.
Their products come with a warranty.
http://malibulights.com/customer_service/contact_us.aspx
http://malibulights.com/customer_service/owners_manuals.aspx

2) If unit can be set to override, you can buy cheap photo eye timer, and then plug power pack into cheap timer, but there is no guarantee this will work, or that power pack will burn out.
http://www.amazon.com/Intermatic-HB61RC-Digital-Outdoor-Control/dp/B00004W4X5

3) Buy ordinary power pack with dial-type timer, and then buy photo eye that fits.
http://www.intermatic.com/products/professional%20lighting/light%20expressions/accessories/ml814drp.aspx

http://store.nexternal.com/intermatic/categories.aspx?Keyword=ML814DRP&x=15&y=10

4) As electrician, I would not buy anything that costs more than $15 that comes with built-in photo eye that cannot be replaced.
Especially something as buggy as a low voltage power pack.
http://waterheatertimer.org/Malibu-power-pack-stopped-working.html

Feb 14, 2010 | Intermatic Malibu 300W Power Pack...

1 Answer

Wiring an inwall timer


Hi,
The white goes to the white, the black power wire to the black and the red wire to the black going to to the lights...

heatman101

Nov 25, 2009 | Garden

4 Answers

My GE 7-Day Digital Timer model 15086 flashes on


I just bought one today and installed it. It does the same thing - flashes the lights off and on. After some research on the net, it seems that the problem is that an old house is wired with two pole wiring and the new fixtures, (timers included) are 3 pole. The conclusion I have found is that it will not work in a 2 pole wired house. There supposedlly are timers available for 2 pole wiring. I hope this helps. If you find out anything different, please let me know.

Oct 17, 2009 | Hardware & Accessories

1 Answer

I have an outside spot light with a motion detector controlled by an inside switch. I want to change outside fixture & install dimmer switch in place of wall switch. I removed outside fixture. There...


First, let me say that if you're not entirely comfortable doing high voltage electrical work, you might want to call an electrician. It's not impossible for you to get hurt or killed or burn down your house. At least be sure to turn of the circuit breaker while you're working on it.

The blacks and whites twisted together are passing through power to other parts of your premises and are always on, so be sure to keep them twisted together. The red is the one that will take power from your light switch and send it to your light fixture.

At the fixture, connect the white to white and red to black, the same as before. At the light switch, connect the black to one side of the switch and the red to the other. When you turn on the switch, it will permit power from the black to travel down the red to the fixture, and from the fixture, the circuit will be completed through the white.

Good luck!

Sep 12, 2009 | Leviton (102-5G108-RW5)

Not finding what you are looking for?
Garden Logo

Related Topics:

721 people viewed this question

Ask a Question

Usually answered in minutes!

Top Garden Experts

Dennis Key
Dennis Key

Level 3 Expert

2478 Answers

roeb

Level 3 Expert

571 Answers

john h

Level 3 Expert

12650 Answers

Are you a Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...