Wii my wii is 3 months old i bought wii fit sychronised it just as instructions said it said it was set press after that moment and till now wii remotes will not work i have re sycronised them slapped them they will not work son took them and they work on his wii brought his sensor bar down and his remotes or mine still would not work di wii fit blow something on my wii

Disconnect the wii from the power cable and let it sit. Then reconnect it and resync the remotes. If this doesn't work make sure you have the most current wii update.

If your are trying to synchronize with the wii remote you should follow steps below:

first, open the hidden door in the front, you wii console(game) find a red button
Open the battery cover of your will remote there you find a red button that looks thesame as the wii button.
Make sure you have batteries on the wii remote

"
wii sync red button --- http://www.zolved.com/UserFiles/Image/wii/syncbutton-console.jpg
wii remote red button------ http://www.zolved.com/UserFiles/Image/wii/syncbutton-remote.jpg
together ----------------- http://wiiportal.nintendo-europe.com/fileadmin/media/customer_services/setup_connect/wiiRemoteSynchStandard.gif "

Turn on you will, press and hold the red button on the wii console for five seconds
While holding it, press the will remote red button too. for 5 seconds

Press A button on the wii remote and if the wii remote light stays on, then your done.

if that didn't work , do it again but this time, press the two red buttons at thesame time and hold it for ten seconds
then Press the A button on the wii remote

good luck

Please rate if this helped you.

Just re sync the remote. I had to do it earlier again when I was trying to fix my Wii Fit Balance Board. :)

You have to insert a wii fit game and bypass all the stuff until the game is ready to play.Open the battery compartment on the Wii board and open the large door on the front of the Wii console.Press the sync button on the board,then press the sync button at the top of the console compartment.The fit board light should stay steady blue.If it doesn't,try it again.When the fit board stays steady blue,it is synched.

try sychronising the console and the board

Fiend your solution direct from nintendo. Here is your solution....
http://www.nintendo.com/wiiconsole/prob676ijt65/solution

cholona13

HI,TV MUST HAVE A SCRAT SCOKET IN BACK?,OR THE WI WOULD WORK ON AV SETTING ON SET ,OR GO THROUGH CHANNELS WITH WI ON AND IT SHOULD WORK,THANKS

1, Turn off and unplug your wii console for a few minutes
2,Turn the power back on and when you see the the safety screen open the small flap on the front of the wii console. Inside you will find the red sync button. Press and hold the red button down for 15 seconds.
* Then remove the battery cover from the wii remote, inside you will see another red button.
* Press and release the red button, the blue lights on the remote will start blinking.
* Quickly press and release the red sync button on the wii console.
* The remote will stop blinking and it should now be synced.
then try syncing your wii fit bored

sometimes just sometimes tvs are funny, some tv's call it a "input select" others call it a "mode" or simply "input" and some dont have any they just want you to goto channel 2 on the tv and go back one more channel.

ushally all these modes are listed on the remote.

is it the origional remote? or is it a universal remote.

try those things above look over the remote again see if anything resembles any of that and if not

list the make and model of your tv and if your using a universal remote we will be able to figure something out for you.

In the Wii settings make sure that the sensor bar setting is correct wheather it is top or bottom of tv. Then make sure the sensor bar is as far font as you can get it to give clear line of sight to the controller.