Hi there, the problem is that the dryer is rotating but there isnt any heat coming through never had to repair it before bought this from future shop in jun look forward to hearing from you

You will need to replace the "high limit thermostat". Under normal conditions, the dryer's primary operating thermostat will cycle the heater on and off to prevent temperatures from rising too high within the dryer. The hi-limit thermostat will remain unaffected through all of these cycles, since the temperature inside of the dryer will stay lower than what is required to activate the hi-limit sensors (generally 250-degrees Fahrenheit, though the exact temperature may vary on some dryer models).
Here is the part you need to order.

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor going bad...

Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

Hi, If you are having problems with your gas dryer not heatingthe most common problem is that the ignitor goes bad. Even though it glowssometimes it is still not working properly. if you dryer is gas check out this gas no heat tip.... If you have an electric dryer, you can have many differentthings that can go wrong causing the dryer not to heat. check out this electric no heat tip...

heatman101 ...........

Number 6 and 15 come in a kit. Both need to be replaced. Why? Because the bigger one is rated for 250f and the smaller one which is bad in your case dies @300F.

These blow when the vent becomes clogged and stops airflow


More repair photos, more heating failure solutions, a video which shows how to break it down, and a service manual is HERE

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Hi,
There can be many reasons why your dryer will not turn...

This tip that I wrote will help you to figure out what is happening...

Dryer Repair - The Dryer is not Turning
http://www.fixya.com/support/r4422207-dryer_repair_dryer_not_turning

Dryer Repair ? The dryer will not start
http://www.fixya.com/support/r4460438-dryer_repair_dryer_will_not_start


heatman101

If your dryer isnt heating properly it could be a couple things. One is that the temp fuse is bad in which case it will need to be replaced. Another is a bad heating element which would also need to be replaced. If you bring the model number of your machine to an appliance parts shop they should be able to get you both those parts and they are relatively inexpensive. However you may prefer to call a pro repairman to come check it out.

Hi, thanks for the inquiry.

It's most likely a thermal fuse. Basically, the voltage has to go through the fuse before it goes to the ignitor.
It should only cost you about $90 to repair if a technician comes out to fix a fuse.
I wouldn't try to repair it unless you have some knowledge of electrics. If your dryer is less than 12 years old, I would recommend you fix it. Hope this helps.

Best of luck :)

I have the same problem and called a repair center to fix. They came out last Thursday and and ordered the parts (thermite and thermo fuse). Waiting for a call that they received and ready to repair.

Hi .check to see if you have 240. volts at the dryer outlet.if you do check the element .do you have a meter to check this with.if no you have to remove the element to look at it . if its broken replace the element . you can buy a cheap meter at radio shack or future shop not very expensive .you should get one ,you will use it often.