At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
When I started to make the azimuth motor rotate, it rotate, suddenly it stopped and warned me.. motor stalled.. With a message of what cold be the causes, but I can restart all the process without moving nothing, oly restarting the regular process by the hand pad. THis is a LX200GPS 8 inchs 2004.
Re: When I started to make the azimuth motor rotate, it...
First, always use a seperate 12 volt power pack and NOT the internal batteries. Do a Calibrate Motors -- first thing whenever you turn on the telescope.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
It'll pay to have the crank sensor checked. They're known for heating up and stalling the car when they're no longer any good. Usually once it has cooled down the car will start but as soon as the sensor gets hot it'll stall again
I was just thinking about the sudden stall problem ,and no start problem .Have you checked the coil pack. When the car is cold it should start ,when it warms up ,with the under hood temps ,it will probably stall ,again. Try replacing the coil pack .
Hope this helps
Sounds like a IAC motor issue (idle air control motor) it controls your idle when you stop or put the ac on it adjusts the idle so you wont stall. it could be dirty or maybe worn out due to age .Very common that they do wear out .
Does it stall suddenly...or start sputtering as if its running out of fuel. The fuel pump stopping shouldn't kill the engine suddenly....each carb will empty and you will lose one cylinder, then two etc.
If its dying suddenly I would investigate your sidestand switch....when the bike stalls...do you ever find the starter won't immediately crank?
Motor Throttling is a warning message designed to protect and prevent the power supply and motor from overheating. It occurs after 30 minutes or so of continuous printing and printing slows down to about half the speed. It will eventually go back to printing regular speed, but if it's that much of annoyance it can be disabled under the printer menu under print control. If you wish you can do that.
Panasonic JVC Description F01 No Take-up reel rotation F02 E03 No Supply reel rotation F03 E02 Mechanism has not unloaded to the eject position F04 E01 Mechanism has not fully loaded to the stop position F05 E04 Rotation of video head has stalled or to fast E06 Tape drive motor is not rotating or stalled F31 Data transmission error F51 Focus motor is not functioning, No focus F52 Zoom motor is not functioning, No Zoom U10 Dew sensor has detected condensation or failed U11 Video heads have been detected as dirty or failed Matti Knuutila[email protected]
Check for binding in the gears; my 10" had aluminium chips in the fork base that jammed the gear. Cured by removing the RA manual adjust assembly - was useless anyway, as it could only be used with the RA unlocked. One setscrew in the fork base holds it in place,just loosen and pull up.
×