Question about GPS

1 Answer

I have an (OLD) Design tech car starter that does not start the car anymore. It will lock the doors, flash the lights but that's it. Can you guide me to a programming manuel for DOC ID: 1467 k1067? It's an FCC Elgtran. Thanks BNill

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

HOW DO I PROGRAM REMOTE ID1476 K1067

Posted on May 24, 2013

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
bwery3
  • 137 Answers

SOURCE: i have had compustar remote

Look down by your feet on the drivers side for a little switch. Theres usally a switch to turn the remote start off. You might have accidently switched it when getting in or out of your car. I have done that before to mine. It should be below the steering wheel under the dash area. Look all around that area for a toggel switch. Good luck.

Posted on May 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is a autocommand model 21921 remote starter compatible with 2007 chevy trailblazer with factory keyless entry


go to IDATALINK.com,you can enter your car specs and buy correct interface module, door locks park lights dome lights and ignition module.i installed audiovox aps 997c remote start alarm with their module works like a champ.VERY INVOLVED INSTALL

Jan 19, 2013 | Design Tech Vehicle Parts & Accessories

1 Answer

I have a 2003 Honda accord that will not start! Tried to jump battery..all fans and belts were running however car would not turn over...bought a new battery and replaced with old now my car want do a


I have seen issues like this on other Honda's and the problem turned out to be the ignition starter switch. Do this, jumper power directly to the starter solenoid trigger wire and see if the engine cranks.

Jun 30, 2017 | 2003 Honda Accord

1 Answer

My car starter is not working. When I push the start button I can hear a click and the parking lights turn on and off again, and then nothing. It doesn't turn over at all.


my car starter quit working. light on the mirror sensor stays on all the time it used to blink off and on. also the dr locks still work when using the remote

Nov 26, 2010 | AutoCommand Remote Car Starter Add-On

1 Answer

Whirlpool washer wont start and start light flashing


Hi, sounds like a problem with the door lock/latch assy.not recognizing the door closed.
Their should be a trouble shooter guide, within the cabinet itself try taking off the bottom access panel and look in side the bottom a tech guide will be in there somewhere..

Take care

Jun 03, 2010 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

Chevy Venture won't start - flashing lights and locking doors


no clicking as if alternator were bad ?? No clicking would be the starter solenoid , not the alternator ! Your best bet would be to take your vehicle to a qualified repair shop . Unless you know how to do automotive electrical testing ! How to use an read a wiring diagram ? We use wiring diagrams to see what all is involved in a system , circuit etc..... An we take training classes !
Basic Electricity for Service Techs Ohm law Current Flow Opens Shorts
Engine Won Start No Crank Diagnosis Troubleshooting Starting System Issues

http://www.bbbind.com/free_tsb.html free wiring diagram !


How to voltage drop test starter motor circuit


Apr 17, 2017 | Chevrolet Venture Cars & Trucks

2 Answers

I got my remote starter to work when i first got the car but now i can't get it to work what am i doing wrong?looked in the manual and turned the key on like it said to do but it still does not start with...


If the remote start is GM, Start the car, shut it off, Get out, lock the doors, Wait for the front end lights to go out, press the lock button, press the start button. The engine should start.

Dec 06, 2009 | 2009 Chevrolet Cobalt

4 Answers

Remote starter does not work but will unlock and lock doors.


I have a 2003 sierra and my remote starter would not work, it would lock and unlock only, checked out this site found the solution, tried it and in two seconds i solved the problem, Just press the lock button and the start button and viola it works again, thanks for all your help , GGGreat site glad i found it John

Dec 08, 2008 | 2005 Pontiac G6

Not finding what you are looking for?
GPS Logo

Related Topics:

392 people viewed this question

Ask a Question

Usually answered in minutes!

Top GPS Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

The Knight
The Knight

Level 3 Expert

74377 Answers

kakima

Level 3 Expert

102366 Answers

Are you a GPS Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...