Question about Apex Digital GT2015DV 20 in. TV/DVD Combo

1 Answer

Color reddish color around images

Posted by on

  • Brandon Higa
    Brandon Higa May 11, 2010

    Is the reddish color present on all sources both TV and DVD?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 291 Answers

Usually, you have adjusted the color too high, back it up a little and reset the other controls

Posted on May 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Akai aled 1605


You don't have a cable connected right. Check alll your input connections and also check what they are connected to.

Mar 05, 2013 | Akai CFTD2083 20 in. TV/VCR/DVD Combo

1 Answer

During a storm, electricity went off and when electricity came on again I lost the color on my tv


Hello,

This means absolutely no color - equivalent to a black and white picture. Not even a hint of color.

First, confirm that the source is actually in color - try another channel or input device.

Next, check the settings of the color control - it may have accidentally been turned down. If your TV has some kind of automatic picture mode, try turning if off and adjusting the color control. Try adjusting fine tuning if you have such a control and the problem is with a broadcast or cable transmission.

At this point with a confirmed color signal source, there is a problem with the chroma circuitry.

Note that to the average person, the obvious question becomes: is my color picture tube bad? The answer is a definitive NO. It is virtually impossible for a defective CRT to cause a total loss of color. A defective CRT can cause a lack of a primary color - R, G, or, B or a short between two colors which will mess up the color but is not likely to result in a black and white picture.

Some possibilities in no particular order:

Weak signal or defect in tuner/IF causing loss of signal strength.

Coler killer set too high (internal control) if it has one.

Defective part around the chroma chip/circuit. Faulty color oscillator.

Bad connections in area of chroma chip/circuit.

Defective chroma chip (don't suspect this first just because it is probably very expensive).

Try prodding the main board around the chroma chip with an insulated tool to see if you can make the color come and go.

I had one set where a .02 resistor decided to open up causing just this problem - perfect BW picture, no color. Another had a coil with a broken wire.

May 26, 2010 | Combination Televisions

1 Answer

Toshiba 32A35 Color TV Flickers & Scrolls w/ light colored images


My Toshiba 27" tv has the exact same problem any solutions out there or is it time to toss the tv?

May 24, 2010 | Toshiba MV19H1 Combo

1 Answer

Red/ Bright Tint/Color on Sylvania SRCD227


Your Logitech Harmony 550 is able to learn commands that are not included in its command database.

To teach your Harmony 550 a new button follow these steps:

  1. Connect your Harmony remote to your computer to start the Harmony remote control software.
  2. Click Devices.
  3. Click a device.
  4. Select Learn Infrared Commands.
  5. Click Next.
I hope that helps.
___________________________________
Harmony 550 Manual Download
Logitech Harmony Firmware Update
Harmony Mac Software Download
Harmony Win Software Download
Logitech Harmony Safe Mode Fix
Harmony Remote Glow Light Fix

Feb 11, 2010 | Sylvania SRCD227 27 in. TV/DVD Combo

1 Answer

Dear Sir My Dvl 919 dvd player component output give black and white images no colour but SVHS have color images.Pls advise Erwin Koh


there are three wires associated with "component output" .. those have to be hooked up to component inputs on your TV .. not to the composite video input .. if you do hook up to composite you will get only a black and white picture .. make sure all three wires are connected correctly then select the proper input in your TV setup ..

Jan 27, 2010 | Combination Televisions

1 Answer

Reddish image


resolder the crt socket board of your tv cause maybe it is only a cold solder....if it sitll doesnt work check the driver transistor of the RGB and if defective replace with a new one with the same value and number......if you cant bring it to a authorized service center of panasonic............

Nov 18, 2009 | Panasonic PV-DM2792 Triple Play 27 in....

2 Answers

Rca hdtv


Check the Fly Back Transformer. be careful when trying to fix TVs. they retain electric currents even if you have disconnected them.

Oct 03, 2008 | RCA D52W135D 52 in. TV/DVD Combo

1 Answer

Color is off the image


sounds like convergence problems solder bad connections k

Oct 30, 2007 | Samsung HC-P4363W 43 in. TV/DVD Combo

Not finding what you are looking for?
Apex Digital GT2015DV 20 in. TV/DVD Combo Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Apex Digital Combination Televisions Experts

The Knight
The Knight

Level 3 Expert

68223 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

5612 Answers

Are you an Apex Digital Combination Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...