Question about Mtd Garden

Open Question

I have a Cub Cadet 4 cycle edger CC 5075 that will not start. Is there a simple way to correct this problem?

Posted by on


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 659 Answers

SOURCE: cub cadet weed eater wont stay running

well the thing I would try is get it running allow it to sit on the ground for a few minutes to run if you do pick the unit up do no point your unit downwards point it up in the air while running for a minute. and when its pointing upward slowly give it some juice to get her going good.

I have a few that are really picky like this as well so I know what your going through it took me some time to figure out a plan to get it going and stay going. but it seemed to work ok for me so maybe it will help you out as well.

Posted on Oct 04, 2008

  • 10865 Answers

SOURCE: unable to serivce or operate cub cadet edgers DE

Hello. go to this link and hopefully you will be able to get what you need

If the manual is not listed call cub cadet and ask them to send you one. Joe

Posted on May 06, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I am looking for a gas cap for a kawasaki engine FR691v 24.0 726 cc on a rzt cub cadet zero turn mower

most garden outdoor ,cub cadet,home stores ,some hardware small engine repair p;aces should have on fixya doesnt sell products

Jul 03, 2017 | Cub Cadet Garden

1 Answer

How do I change the engine oil on my Cub Cadet DE Lawn Edger ?

yes check either side of the block . possibly under neath too

Apr 20, 2015 | Cub Cadet Garden

1 Answer

Cant keep running and it wont throttle up just purchased fall 2013. Hard to get started and wont stay running

Was it like this when you first got it ? If not then if you ran it with the choke on and also using the throttle the mixture would be all to pot.

Try applying throttle gradually.

hope this helps :)

Apr 27, 2014 | Cub Cadet BC509 18" 29cc 4-Cycle Gas...

1 Answer

Almost new GC145-started fine last time. this time it looks like no gas is getting into the primer bulb. add gas there, it starts and then dies.checked the hoses and they aren't clogged. Any ideas? Thanks!

You can use programs like "Driver Tuner" to find out if an old or wrong driver is installed. This software can automatically find and download correct drivers.
Disclaimer: Not associated with software vender but have used this software to fix driver issues on couple of computers.

Nov 03, 2013 | Cub Cadet 9 in. 26 cc Gas 4-Cycle...

1 Answer

Unable to serivce or operate cub cadet edgers DE

Hello. go to this link and hopefully you will be able to get what you need

If the manual is not listed call cub cadet and ask them to send you one. Joe

May 05, 2010 | Garden

1 Answer

Cub cadet 4 cycle weedeater

undo the bolts at the rear of machine first then access inner bolts holding engine to remove then work forward

Aug 21, 2009 | Garden

2 Answers

Problem with left side hydrostatic transmission

This is a well documented problem with cub cadet ZT transmissions. They tend to go bad after 200 hours of use. Sometimes having the dealer change the transmission oil will help (they need to remove the transmissions to do this!). Most times, the transmission is gone & must be replaced ($800-$900).

Sound to me like a design defect. My ZT-50 lasted only 4 years. Needless to say, the replacement was not a cub cadet.

Jul 03, 2009 | Cub Cadet Street Sign- tractor lawn riding...

3 Answers

Cub cadet weed eater wont stay running

air vent in gas cap pluged, push a pin through it

Oct 04, 2008 | Craftsman 25cc Gas Line Trimmer

Not finding what you are looking for?
Garden Logo

Related Topics:

356 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mtd Garden Experts

Roland W VanLue
Roland W VanLue

Level 3 Expert

486 Answers

Tim Whalen

Level 3 Expert

3074 Answers

Phil Walker
Phil Walker

Level 3 Expert

608 Answers

Are you a Mtd Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides