Question about Flotec 1 Hp Deep Well Pump

1 Answer

I installed a 1hp flotech today at 160 ft and 210 ft to house..it ran for 10 minutes and shut down while flushing line to outside of house..would not restart ...check voltage at 220...checked circuit and showed closed...any suggestions...hate to pull pump if not necessary!

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 43,501 Answers

Hi,
No either you got a bum pump or the wiring came apart in the well...

heatman101

Posted on Sep 29, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 liebherr 912 running for 10 minutes and then shuting off


Hi There maybe dirt in the bottom of the tank plugging the line up.
also check for air in injection pump. The pump must be blead out.
Hope that helps.

Jan 13, 2014 | Liebherr Excavator

1 Answer

Maytag neptune dryer doesnt heat


On the housing the element mounts in is a couple of safetys The smaller one is rated for 300f and the bigger one is rated for 250f. If the smaller one is tripped obviously you replace them both, making sure the vent to outside is clear. Them fuses blow or trip because of air restrictions.

Aug 04, 2012 | Maytag Dryers

2 Answers

1996 honda accord starts up fine runs 10 15 minutes engine shuts down wait 5 ,10 minutes starts back up shuts off short time after


sounds like there could be a problem somewhere along the fuel line either between the pump and that engine or between the filter and the engine i have a car that would do the same thing turned out to be the fuel filter was full of **** ran like a dream after i changed that.

Jan 10, 2012 | 1996 Honda Accord

1 Answer

AC not cooling


first off you should have a four ton unit. what is your super heat? is it pulling attic or outside air?

May 27, 2010 | Goodman CLQ36AR49 Air Conditioner

2 Answers

Compressor shutting down


FC IS FREON CHARGE, WHAT YOU ARE GETTING IS A HIGH PRESURE CUT OFF  FAILURE. THE LABEL PRESURE IS TEST PRESURE. THE RUN PRESURE ON LOW SIDE IN AC MODE IS ABOUT 65 AT 75 T0 80 DEGREES INSIDE AND ABOUT 200-300 HIGH SIDE AT 75 -85 OUTSIDE TEMP. IN HEAT THE LARGE COPPER LINE BECOMES HIGH SIDE HOT WHEN YOU FEEL IT. IF YOUR FREON IS LOW WILL WILL ALSO GET SHUTDOWN. YOU WILL NEED SET OF FREON GAGES AND CONTACT ME BACK

Apr 23, 2010 | Heating & Cooling

Not finding what you are looking for?
Flotec 1 Hp Deep Well Pump Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Flotec Garden Experts

Jay Finke
Jay Finke

Level 3 Expert

1338 Answers

Ryan Ross

Level 1 Expert

19 Answers

ray gallant

Level 3 Expert

41466 Answers

Are you a Flotec Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...