Question about JVC RX-5030/32 Receiver

1 Answer

No sound from subufer

I tried many ways but no sound from sub bufer

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Asked JVC global and downloaded the Manuel from Germany followed instruction and solved the problem

Posted on May 25, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Yamaha HTR 5960 receiver hooked up to a Klipsch 10" synergy sub. The system has been set up for about 6 years and the sub suddenly quit working. I have checked connections and the sub is getting...


If you remove the signal cable from the amplifier while the Sub is switched on (turned down about half way) you should hear a thump sound. If you do that proves that your sub is working and you need to look at your Yamaha. Perhaps the sub channel has been disabled in the logic settings. Check the speaker configuration pages. If all looks well reset your amp to factory settings and try again. I have had a logic glitch which was fixed in this way.

Nov 23, 2013 | Audio Players & Recorders

2 Answers

I have 2 peavey sp 5 and a pwavey 2600 amp . i wanna know can i hook a peavey 118 passive sub to one of the sp5 and how would it sound?


You would send high as well as low to the sub and unless the sub had a built in crossover it COULD get muddy sounding. The specs SEEM to indicate the 118 DOES have a low frequency crossover so it SHOULD be OK... How would it sound? An 18 inch sub normally adds to the sound of a system... You MAY need to PAN over to send more power to the one side with the extra load on one side. Often people use two sub's... one for each side so it is balanced.

Jan 19, 2011 | Peavey SP5 2-Way PA Cabinet (800 Watts, 15...

1 Answer

No sound from sub


simply give it a 2 wire signal and you should hear something! if not then depress the cone lightly back and forth, if you hear alot of scratching/scraping sounds, prognosis in not good.

Sep 15, 2009 | AudioBahn AWES12P Car Subwoofer

1 Answer

I have a 2channell FE-402 fusion amp,with a fusion sub,and a set of vibe k-series 69's that have a max power of 525 watts. I tryed wiring the sub with the speakers and the speakers sound fine but the sub...


Hello jackstephens,

It's an either/or situation. The FE-402 can be set up to drive normal speakers in stereo, OR drive a sub when both channels are bridged. When the LP filter is on, it benefits the sub at the expense of the normal speakers. And with the filter off, the subs get the full range of frequencies and try as best they can to reproduce them. You might try running it with the LP on, in stereo with the 6X9's paralleled to one channel (2ohm load), and the sub connected to the other channel (?ohm load).

But my recommendation would be to use the Fusion amp the drive the 6X9's and get a dedicated monoblock for the sub.

Hope this helps.

Jun 06, 2009 | Kicker KX500.2 Car Audio Amplifier

1 Answer

Trying to install a subwoofer on a 97 crown vic


Make sure you are using a 12volt DC system in both units. It may sound simply but an AC sub may need an inverter. Also check grounds.

May 21, 2009 | 1997 Ford Crown Victoria

1 Answer

Spl 620 wn put out loud enough does have sound did i wire it wrong?


Hello ace_sterling,

Not knowing what you have the SPL-620 driving or knowing how you have it wired, it's rather difficult to determine if it's wired "wrong".

I show the SPL DK2-620 as being a 2-channel amp with 150 watts output at 4 ohms, or 180 watts at 2 ohms. Even if the power is somewhat overrated, it should provide more than enough power for a set of standard 2-way or 3-way speakers, or component speakers with a separate crossover.

Powering one or more subs is another thing. You would get sound, but the subs would not be very loud. In bridged mode, the amp is only stable to 4 ohms. So if you are trying to power 2 4-ohm subs, the best connection would be 1 sub connected to each channel. If you are powering only 1 sub, then the bridged connection would be best.

Hope this helps. If it does, please rate as "FixYa".

Apr 23, 2009 | SPL Audio Car Audio & Video

1 Answer

Problem when hooking two 12 inch subs to one amp


the amp is no where near strong enough that sound you hear is called hard clipping and it will destroy your subs in minutes. depending on what model JL subs you have I can sell you a better amp.

Dec 30, 2008 | Planet Audio VX602 Car Audio Amplifier

1 Answer

Improper function


try hooking up your subwoofers in series. then connecting them bridged to the amplifier. as follows: positive from sub#1 into positive of amplifier left channel.. negative sub#1 into positive sub#2. negative sub#2 into negative amplifier right channel. turn the gain down as this will sound pretty loud.

Jul 13, 2008 | Pioneer Car Amplifier GM-5100T - 2CH 760...

1 Answer

Minimal sound from the sub, all other speakers working fine


You should try to increase with remote of your yamaha the sound level for sub.In my Pioneer receiver I can increase level from minus 10 to plus 10 DB

Apr 05, 2008 | Yamaha HTR-5650 Receiver

Not finding what you are looking for?
JVC RX-5030/32 Receiver Logo

Related Topics:

204 people viewed this question

Ask a Question

Usually answered in minutes!

Top JVC Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

4946 Answers

The Knight
The Knight

Level 3 Expert

73150 Answers

Henry  Thomas
Henry Thomas

Level 3 Expert

1074 Answers

Are you a JVC Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...