Question about Whirlpool Washing Machines

1 Answer

I have the duet sport washer, and it is shaking violently. I have already leveled the washer and tightened the feet.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 135 Answers

Are the shipping bolts removed from the back? There are 4 of them.

Posted on May 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Severe shaking when spinning out


it could be you have to heavy a load or you do not have the washer level. Most washers have screw out feet that can be adjusted to keep them from shaking so violently the best thing to do is set a lever in different positions and directions on the top and level it completely and see if that does not fix your problem.

Dec 23, 2012 | Kenmore 44102 Front Load Washer

2 Answers

Washing machine shakes violently during spin


Hi

If your washing machine shakes violently or if there's a loud thumping noise during the spin cycle, the load of clothes has probably gotten unbalanced. Open the lid, redistribute the clothes in the washer, then re-start it. Repeat these steps if necessary.

Also check this link bellow:-

http://www.wikihow.com/Fix-a-Shaking-Washing-Machine

May 03, 2011 | KitchenAid Washing Machines

1 Answer

I have never been so unhappy with a washer as my Duet front loader. It SMELLS horrible at times, spins and shakes violently. My clothes are always in knots, especially the sheets. My first Whirlpool and...


We had problems with ours shaking but it wasn't completely level.. But I use the clean washer cycle that uses bleach only and it works pretty good. Other than that, I don't have a clue..

Apr 22, 2011 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

Washer is shaking around when washing it moves around about 6 inches every wash


You will need to adjust the feet on the bottom of the Washer so that they sit level on the ground. If you lift up the ends of the Washer you can either screw the feet in or out to level the Washer, and then tighten the nut down on the feet to keep it tightened.

Aug 13, 2010 | Whirlpool Calypso GVW9959K Top Load Washer

1 Answer

My brand new amana washer shakes violently when spinning


try adjusting the feet on the bottom of the washer the floor may not be level to adjust the legs turn them with a wrench or if the lock nuts are not tight turn the legs clockwise as you look at the front of the machine till all four feet are sung on all 4 corners. This is the most common problem. hope this helps and thanks for using fix-ya

Feb 15, 2010 | Washing Machines

1 Answer

Our sport duet washer shakes violently even thou it is level


Under neith the tub is a series of shock absorbers like on a car, from time to time these come loose or fail. I have a duet repair manual:HERE

Jan 24, 2010 | Washing Machines

2 Answers

Shook Violently first time on spin cycle


Make sure the washer is leveled properly and all four feet are resting on the floor. If it is level, try running one cysle without any clothes in it to see it is spins without that violent shaking.. you may have also had an out of balance load.. Hope that helps!

Aug 13, 2008 | Samsung WF337AA Front Load Washer

3 Answers

Whirlpool duet sport..vibrates during spin and "walks"..on pedistal.sitting on tile


I just bought this washer and had two problems with it. 1 the vibration at medium spins and 2. a squeeking spring (every time the drum rotates a little squeek, but when spinning the squeek sounds constant.

What I discover in solving both my problems with the same solution. I had to ensure all 4 feet well on the ground and that the top of the washer was perfectly level. At one time I was out only about 2 mm on one side, but the bubble was slightly to one side on the level but still in between the level's markers. I tested with a load, and both problems were still there. Turn feet 1/2 turn on the side needing adjusting. Ran another load and you guessed it, no squeak, no vibration, spinning was quiet, I had to go over to check to see if the machine was going through the cycles. I couldn't believe that a few millimeters could make such a difference.

Now I am pleased with the performance, not to mention how clean the clothes are and the savings on water and drying.

Feb 12, 2008 | Whirlpool Duet GHW9150P Front Load Washer

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...