Question about Washing Machines
I had the same problem and the code f01 would flash, I could select the wash and make selections with all the other buttons but once I pushed start it would flash f01. I fixed the problem by not turning the machine off and pulling the power cord out of the wall and it seemed to reset it. I could immediately turn the machine on and it stared working.
Posted on Jul 23, 2008
Put in a new pc board $161.00 takes 15 minutes to put in take top off it is on the right side white box 6 inches by six inches computer brain just replaced my wifes easy fix, all it would do is flash F01
read paper inside bottom mettle kick plate take it off with three screws paper is inside of kick plate tells your codes F01 is cpu board replaced my wifes works good now Thanks
firstname.lastname@example.org for info
Posted on Jun 04, 2008
So... I got home after working out in the hot FL sun for 12 hrs. My wife says the washing machine is flashing a code and is filled with water. I turn it on and flashes F-01 code. I go to my computer and do my DIY search on the code for my Maytag epicz. Did the push button thing, the pull the cord thing with no luck. Anything to avoid buying a $250 control board. Pulled pressure hose off sensor on top right center under the top cover and replaced and got the machine to run but still would not drain. I have six kids and have to clean out drain trap on a monthly basis. I have replaced the motor about 2 years ago due to broken impeller. So after draining I dumped out the $4.00 in change, penciles,little beads, rocks, hair,and gum wrapers. Maytag did awesome with the huge hard plastic trap in my opinion with six kids. Motor was not running and I noticed it was rather hot . So I took motor out and noticed something wraped around the impeller like a latex glove. Put motor back in and runs like a matag champ again. I am sooo happy that my Maytag's EpicZ F-01 code does not mean a $250 dollar borad but means condom stuck in the motor impeller..LMAO..
Posted on Feb 06, 2014
I pushed pause cancel twics and it reset and started working
Posted on Jul 22, 2011
SOURCE: Maytag Epic-Z F-28 error code
F28 is a misc error,
most of the time it is because the washer is NOT LEVEL.
1. Unplug waher,
2. Relevel washer. (make sure all legs are equally distributing weight, so as to ensure no shaking). See owner's manual.
3. Plug in, and use.
Hope this helps.
Posted on Oct 04, 2009
Tips for a great answer:
Jun 24, 2011 | Maytag EPIC MFW9700S Front Load Washer
May 08, 2011 | Maytag EPIC MFW9700S Front Load Washer
May 02, 2010 | Maytag EPIC MFW9700S Front Load Washer
Oct 16, 2009 | Maytag EPIC MFW9700S Front Load Washer
Jul 01, 2008 | Maytag Washing Machines
Jul 01, 2008 | Maytag EPIC MFW9700S Front Load Washer
2,561 people viewed this question
Usually answered in minutes!