Question about Bosch WFMC2100UC Nexxt Essence Washer

1 Answer

Frabic Softner Dispenser

When we put fabric softner in the washer it just sits there and won't run out. What could be the problem.

Posted by on

  • drauser50 Nov 02, 2008

    How do you fix that problem?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The water valve for the softner is not opening. depending on the model, you can put unit in a service mode. this will let you cycle through the valves.

Posted on Aug 17, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you get the agitator to come out the fabric softner dispenser is filthy and all needs to be cleaned


Hello,

By grasping just the fabric softner dispenser and wiggling it from side to side while pulling up the softner dispenser will come out to be cleaned.


GENE

Oct 13, 2011 | Whirlpool Ultimate Care II LSQ9564J Top...

1 Answer

The frabic softner dispensor is not releasing the softner in the washer.


Hi,

Here is a tip that I wrote about what I found out about the fabric softener not dispensing into the washer...

Fridgidaire Washing Machine Fabric Softner not going into washer

heatman101

Sep 05, 2010 | GE WSXH208A Front Load Washer

1 Answer

The fabric softener is clogged with dried up fabric softener on my Whirpool Washer. How can I get it cleaned out?


You really cant take them apart without breaking the dispensers. Fabric softner is basically wax and fragrance. Add very hot water to the dispenser to melt the fabric softner. In the future, water down the fabric softner.

Feb 13, 2010 | Whirlpool Cabrio WTW6600SBT Top Load...

1 Answer

FABRIC SOFTNER DISPENSER NOT DRAINING


you can try putting a dishwashing tablet in it with some hot water and let it sit overnight ...the tablet has something in it made to desolve build up for water ,soap,ect...and it safe to the washer and to you too.I used one in my water drain on a water in the door ice box worked like a charm.

Dec 03, 2009 | Kenmore Washing Machines

3 Answers

The fabric softner release has stopped working


Most likely the fabric soft dispenser is clogged . this happens when you wash alot in cold water the left over fabric softner get very pasty and can clog it up. You can try filling the dispenser with hot water and run a cycle with hot water this should unclog the dispenser .

Nov 26, 2009 | Hotpoint Aquarius WMA42 Front Load Washer

1 Answer

The fabric softner dispenser is clogged. it fills


Pour really, really hot water into it and that should disperse the fabric softerner...then run the washer with NO clothes in it...good luck

Aug 11, 2009 | GE Washing Machines

1 Answer

Maytag MTW5620T2 the fabric softner despenser doesn't despense. There is mositure inside and it slings fabric softner everywhere. It leaks from the side hole of the agitator. Gets fabric softner on my...


Liquid Softener was clogged up over time.
1-Put hot water in the place of the Softener slowly and let it over flow to dissolve the solidified liquid.
2-Keep doing this until you see water at the bottom of the tub.
3-Run a small load to clean out the gum.

Jul 02, 2009 | Maytag Washing Machines

2 Answers

Fabric softner dispenser


Small brush and plain water. Rub, flush, repeat...

If it's clogged where you can't get a brush, pour very hot water into it. Last resort would be blowing it out with an air compressor...

May 07, 2009 | GE Profile WPRE6100G Top Load Washer

1 Answer

Fabric softener dispenser is filled with water


I had this same problem. I found a repair manual online and found out how to get into Service Test Mode. There is a test (t12) for the dispenser motor/mechanise. Running this test basically just runs water through each of the dispenser compartments (prewash, wash, bleach, fabric softner). All ran fine - no error codes. I continued to run the test on the fabric softner dispenser repeatedly and after 5-10 cycles it started draining properly. I think a tube (or valve or opening) was just clogged with the built up softner. I also put some vinegar in the compartment a time or two just to clean out any residue. Be careful with the Service Test Mode - read directions carefully - the manual warns that if you don't get out of it corretly that it can lock up you washer.

Jun 18, 2008 | GE WBVH6240F Front Load Washer

2 Answers

Fabric softner is building up in dispenser


Same deal - I have to soak up all the residual water in the softener dispenser between washes. (The detergent and bleach compartments are fine).

Jun 13, 2008 | GE WSXH208A Front Load Washer

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

268 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bosch Washing Machines Experts

Tim Whalen

Level 3 Expert

3056 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Are you a Bosch Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...