An expert who has achieved level 2 by getting 100 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Printers & C... Expert
Re: Ricoh 3245C Copier
Are you sure the problem is with the pcb? Did you chk all of your sensors/ flags to see if they are working correctly? Or have you seen where it stops all the time for a pinched wire? Or did you seen the pcb give up it's Smoke signal???? How about the solder joints on the pcb? You may have a hard time finding that pcb... Good Luck
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If you go into the print driver settings (Control Panel > Printers & Faxes > right click on the Ricoh 2027 and select Properties) there is a list of the available accessories under one of the tabs (I think it's either Accessories, Advanced, or something similar). Depending on the specific driver you have, you can either check the option for the duplex unit and then click Apply, or you can click the Update Now button to have the software itself check to see which options are installed on the copier.
Either way, you should be able to print duplex copies once you've done of those two things (assuming you actually have a duplex unit installed on the copier, of course).
There are certain models that can duplex and certain models that can't. Generally if a Ricoh copier can duplex it has a D after the name (like 2018D). If there is no option for duplexing on the screen or the ops panel, that model doesn't support duplexing.
670 D Engine response error
After powering on the machine, a
response is not received from the
engine within 30 seconds.
• SBCU installed incorrectly
• SBCU defective
• Controller board defective
You can try to reseat the connectors on those 2 boards, if that doesnt work you may need to replace those boards.
Hello sir; There have two way to resolve this problem, 1st, loose the cover hinge push cover all the way to front then tighten it. then go to 2nd step open the top cover, at the left side of the white padding there have to lockes (up & down) open it out look inside there have a reverse roller, clean it with alcohal, hat should take care the problem.
· Scanner home position sensor failure
· Defective scanner motor
· Defective main motor
· Defective dc power supply board
· Incorrect scanner drive wire position
· Defective dc harness
· CN103 or CN105 on the main board is not correctly connected.
· FU202 on the dc power supply board open (blown fuse).
Controller to operation panel comucation error at start up.Check the controller stall,controller board installed correctly operation panel connectors.Enter im the service menu ,press the SP mode,open the front door,turn off the copier,unplugged the machine.Wait 10 seconds,plugged on the machine,close the front door,turn ON the copier and make a copy.