Question about Projection Televisions

Open Question

Panasonic tx28ps12 ctv tv turns itself off flashing red light three times per cycle each time in trying to switch it on

Posted by on

  • Anonymous Jan 19, 2009

    TV starts to come on then trips with led flashing 3 times

×

5 Suggested Answers

  • 1 Answer

SOURCE: TV won't turn on

problem is fan stoppage this is probable caused by excessive
dust in fan take off back and locate visually the cooling fans in unit
use canned air to remove dust until fan moves freely. if all fans
are clean maybe one fan is not giving rotation detect signal
look at voltage on white or yellow wire from fan s/b 5v then 0v
when fan rotates if one stays at 5v replace it

Posted on Feb 15, 2008

Slinteriors
  • 8617 Answers

SOURCE: panasonic pt-53wx53g tries to turn on but goes right off

That is indicating that the convergence circuits have shutdown the set. You will need new Convergence ICs. They should be STK392-110 or STK392-120 either number works the 120 being the better chip. I will post a link where you can get the new ICs and they provide step by step instructions with pics so you can do the repair yourself. You will find your IC numbers under the section titled Convergence ICs just click on that and you will find your STK numbers.
http://servicemanuals.vstore.ca/

Posted on Mar 30, 2008

abhishek33
  • 1239 Answers

SOURCE: red led light flashes 6 times and tv won't turn on

Hi friend,,,,,,
it is an indication of an error code ,,,,,,normally 6 blinking code refers to an power set up problem,see incoming voltage with an multimeter.......

thank u,,,,,,,,

Posted on May 03, 2009

  • 2 Answers

SOURCE: My Panasonic PT-60Dl54J tv shut itself off and the

This is straight from the service manual (I'm not sure what the problem is but it sounds serious):

8.2. Power LED Flashing timing table
When an abnormality has occurred, the protection circuit operate and cuts the power supply. At this time, the defective line can be
identified by the number of flashes (red) of the power led indication at the front of the unit.
NUMBER OF FLASHES CIRCUIT MICRO PIN
1 LOAD SHORTAGE 92
2 OVER VOLAGE 93
3 FAN SOS 94
4 MAIN 3.3V 88
5 LAMP DISABLE 61
6 GC3FM-IIC IIC
7 GC3FS-IIC IIC
8 GC3I-IIC IIC
9 COLOR WHEEL STOP 110


Posted on Mar 14, 2010

welcomejee
  • 10594 Answers

SOURCE: i have a pt-47wxc43g panasonic

Hi,
Three times red light blinking indicates problem of convergence output chips are bad, tv has 2 chips that need to be replaced.
Let me know if you are handy with electronics stuff repair and can replace/ solder parts in circuit board to provide you technical info OR local tv repairman will do this job for you.
Thanks.

Posted on Dec 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 56 in hdtv Panasonic tv will not come on green light flashes 20 times then goes to red. Help, on disability fixed income & cant afford to get repair or new tv. Please help, as soon as poss


Panasonic Plasma TV Repair - Understanding 14 Blink ...

? 8:35
https://www.youtube.com/watch?v=iHBIiRxhe0w
Sep 26, 2014 - Uploaded by ShopJimmy.com
Panasonic Plasma 14 Blink Code Explained with Repair Info How to ... I guess I'll try the SC board and if that does not work simply save up for a new ... The red power led was flashing 12 timespause a few seconds then flash 12 again. ... It powers up and shows the green power light is on, but there's no ...

The power light keeps flashing and the tv wont turn on - TV ...

www.tomsguide.com/answers/id.../power-light-flashing-wont-turn.html
Oct 24, 2015 - More about : power light flashing wont turn ... December 20, 2013 10:12:55 AM ... sound like it is coming on then it shuts off and the red power light flashes slowly. ... 50in Plasma tv power light is flashing 8 times and won't turn on. ...tv to come on bcause the power button keep blinking my tv will not come on.

Nov 06, 2015 | Panasonic Projection Televisions

1 Answer

Hello. My Panasonic PT-50LC13 is not turn on. First flashing green light for one minute on the power button then starts to blink red and at the same time it starts blinking red LED lights every five...


Check ur tv fan,if ur cooling fan are runnig,before all these LED lights are flashing.If not that ur tv problems.All these LED lights are flashing the tv making alots of clinking noises too like it trying turn itself on?Yes,than the tv board that called the Ballast board it is dead too,must be replace also.This tv Ballast board only job are to help to ignite the tv projection lamp only and keeping it on and running.

Aug 29, 2011 | Panasonic PT-50LC13 50" Rear Projection...

1 Answer

I have a Panasonic PT-50DL54 50" rear projection tv. My tv screen won't come on but the fans will. The power led light flashes green like normal but than starts to flash fast for about a minute than the...


Time to get a new TV. I have similar problem. In my case, the set turns off, LED blinking green for about a minute or 2, then the set will turn on by itself. Something the LED started to blink yellow after blinking green and then shuts off. I can turn it back on. This happens 3 or 4 times in an hour. After that, the TV stays on for as many hours as I want until I shut it off.
And then the problem repeats everytime I turn it on from a cold start.
I have my eyes on the 50 inch Plasma from Panasonic. Bestbuy has one for 999.99.

Jun 14, 2010 | Panasonic PT-50DL54 50" Rear Projection...

1 Answer

TV turns itself off after being on a few seconds, ...


Hi,
Three time blink means tv got problem in convergence output circuit, replace convergence output ICs to solve the issue.
Thanks.

May 21, 2010 | Panasonic PT-53WX54 53" Rear Projection...

2 Answers

What are the error codes for a Panasonic PT-47WX 42 TV


Hi,
3 times LED blinks in Panasonic PT-47WX42 shows problem with convergence out chips failure as this tv has two big black ICs STK392-110 as convergence output, replace them to fix tv problem.
Click Part Store to see an image of required chip and price info.
Local tv tech is recommended if you have no experience of working in tv circuit boards.
Thanks.


Apr 18, 2010 | Panasonic PT-47WX53 47" Rear Projection...

1 Answer

Panasonic LiFi model number PT-50LCZ70. Have red lamp light flashing on front 2 times. Have tried to turn it on and get no picture and no sound at all. I checked and the fan is running. What now?


After the red 2 flashing starts, press the power button on the front of the TV and hold pressed down for ten seconds.
You will hear a faint click comming from the back of set.
After 10 sec release the button and wait 10 more seconds then press the start button and release right away.
The green light flashes and the bulb attempts to start.
I found my picture will turn on on the third attempt of the bulb restarting.

When you do this and the room is dark you can see the bulb attempt to restart, My bulb has restarted on the third restart every time.

(note: The three start attempt happen after I do the button pressing
1 time and I do not need further button pressing restarts.

I think panasonic needs to let us know what the problem is.

I called Panasonic and they told me to plug it into a wall plug by itself.

I have it plugged into a multi plug adaptor now and have not tried this yet.

Nov 06, 2009 | Panasonic PT-50LCZ70 50" HDTV

3 Answers

Panasonic pt47wx52cf tv shut off and wont turn


Please count red light flashes and let me know. There would be long pause between flashes so count pause to pause. It is an error code of TV problem.

May 18, 2009 | Panasonic Projection Televisions

1 Answer

Won't turn on, flashing red light


It seems you ballast is going out, i recommend you replaced, don't waste money buying lamps with this issue, get the ballast, they run around 60dll so it's a good deal, go to discountdashmerchantdotcom i've been getting parts from them and they offer great service, it's worth giving them a shot :)

Oct 09, 2008 | Panasonic PT-53WX53 53" Rear Projection...

2 Answers

Won't come on


hy i got a toshiba 42" LCD tv ,when i press the power boton
iget the red light,& it stay that way ontil i pressthe power back off
thanks for any help

Jun 26, 2008 | Toshiba 62HM95 62" HDTV

1 Answer

TV won't turn on


problem is fan stoppage this is probable caused by excessive
dust in fan take off back and locate visually the cooling fans in unit
use canned air to remove dust until fan moves freely. if all fans
are clean maybe one fan is not giving rotation detect signal
look at voltage on white or yellow wire from fan s/b 5v then 0v
when fan rotates if one stays at 5v replace it

Jan 07, 2008 | Panasonic PT-50DL54 50" Rear Projection...

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

141 people viewed this question

Ask a Question

Usually answered in minutes!

Top Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

yadayada
yadayada

Level 3 Expert

61168 Answers

Are you a Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...