Where can I find a replacement printhead for my Canon Pixma ip5200? Local office supply stores have all cartridges but no printheads. Office Boy Richmond, VA

The printheads for this printer are part of the ink cartridge. They can be cleaned by sitting the bottom of the cartridge (where the printhead is) in a shallow dish of warm water to dissolve the dried ink. Blot on a dry tissue (dont wipe) then try print again.

Remove your black cartridge and check that the ink might be over flow or block.... so clean it up with soft paper... thanks

how did you fix this problem?

You can get the error from having a bad printhead also. You can probably find a new one on ebay for cheap. Here is the part number: QY6-0052-000. SOme office supply stores alsocarry them.


Best of luck..

Hello!

Please check the "Rplacing an ink tank" part of the manual. Hope it will help you.
https://manualsbrain.com/en/manuals/1796179/?page=45

The cartridge is only a tank that holds ink. The printhead is the device that you put it into and probably has a blockage in the magenta head. Open the machine so the carriage moves to the center. remove all the cartridges.
TCT How to remove and clean Canon Printhead see the link below. The MX700 may have the locking mechanism at the front of the carriage, so you should move it slightly right and then pull the colour bar forward to release the printhead. carefully remove the printhead. Sit it in a shallow dish/tray of hot water for a few minutes and dry with a paper towel. Put it back in the printer reset the locking bar and cartridges. Try a nozzle check through the tools menu. Yoyu may need to repeat the process if the magenta printhead is badly blocked

Strip out the cartridges, remove the printhead and clean. Reset the printhead and all will be ok.

20 times Other hardware error [6500] - Logic board ***'y (QM2-2670)*1

Its the small circuit board next to the carriage unit

You can get one for about $30 from this company web site.

www.euro-parts.it/download/slowmover_oct-2008.xls

You probably have to contact them directly to get your exact circuit board.

The yellow may be clogged. Try cleaning the printhead by removing it from the printer and soaking the bottom (half inch deep) of printhead in warm window cleaining solution for a few hours.

303Electronics eBay Stores

If you need further help, I’m available over the phone at https://www.6ya.com/expert/alex_22751bbefa74c3d0