- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I'm guessing at some point I pressed down too hard on the power button and either broke something or mis-aligned it to what mattered.
If this happens to you:
<li>Plug the headset into the (connected) USB power cord</li>
<li>Blue light comes on</li>
<li>Unplug - Headset should remain on</li></ol>
<li> If you leave it plugged in until it turns red (charging) then it will turn off when you unplug it.</li>
<li> If your headset doesn't show a blue light or any indication of life, something beyond the power button is wrong.</li></ul>
The only way to reset something like this is to remove batteries for a bit. Once all capacitance charge is spent, probably 30 seconds at most, units will be at factory settings. I doubt that this will work on a headset, but it is all I got. Take the headset back for warranty.
This is caused by a power surge. To correct, plug your headset into charge, and then plug into power strip. Trip the switch on the power strip to off. It will cause a drain and turn off your green light and then allow the headset to turn back on.
Have you shut off your bluetooth through your phone settings? Try that and even disconnecting altogether, then adding again. Keep it charging and make sure the lights all come on for charging and when turning on your set. Let me know what happens at this point
Start with the device off but fully charged. Press and hold the call
control button for 8 seconds; at this point, you'll see the light flash
blue then red. You'll have two minutes to connect it to your new phone. Use the passkey 0000 after your phone finds the headset.
If you're resetting it one you're phone just delete the device in your bluetooth setting and set it up again. If trying to reset the bluetooth headset, hold the power button until the blue light stays on. That should do the trick.