White screen with Battery Icon never goes away

The red clamp on the charger goes to the + sign on the battery. The black goes to the -. I you want a deep charge(best) set the charger on 2 amps and run it for 8 to 12 hours. If you need to get the car started, set the charger on 225 amps for just a couple of minutes. Start the car while it is on..2 amps can charge forever. 20 amps for 30 minutes. 30 to 40 amps for 15 minutes. 225 amps for five minutes..DO NOT charge 20+ amps for hours. It will kill the battery

yes of course, you need a new battery.
when you get this battery, also buy a universal charger.
do not insert the battery into the phone until you charge it for 3 hours with the universal charger.



after that the phone will work very fine.

You will need to purchase a new battery for your device. The batteries are not very expensive and are very useful

try removing the battery . wait 30 minutes. plug the battery back in and try again.

Charging duration does not connect to battery lasting duration in any way.Optimal charging time is 3 to 4 hours.your battery will drain soon if you keep your touchscreen pressed continuously in your jeans pocket.Keep bluetooth switched off. Reduce the brightness of your mobile display. Play music threw headphone rather than using loudspeakers.

ok, what you need to do is take out your battery.....
it is suppose to be out for about 30 seconds to a
minute....however long that you choose.....
it is suppose to reboot your phone, its sort of
like restarting your computer....just try that and
then after you put the battery back in, just plug
in the charger and let it do it's thing.....dont turn
on for about an hour till fully charged.......
and if that doesnt work i would take it to
att to have them experiment with it

Take the phone to a mobile service center and have the flexcable replaced on the phone.

u lost ur device display
replace with new display.

the white screen is because the 'flex' is broken. u need to change it. the 'flex' is a part that connects the upper part ( screen) and the lower part (keypad) of the cellphone. the flex is a common problem with flipflop phones. i dont know if u can get it in your country, but we have lots here. it costs around $14-15 including labor.

i was able to solve the white screen problem, but one of the 2 problems w this cell still exists. Whenever i close the flipflop, "memory card removed' appears, and it keeps blinking. Or when i charge my cell, this msg also appears. this also drains my batt. If i reinsert my memory card, it solves the problem, but whenver i charge my cell, it appears again. So its kind of a hassle to always open the back of the cell to reinsert the memory card, so what i do is , i never close the flipflop. Anyone has the same problem?

I looked up the battery specs for your phone. They are 3 X 200mah= 600mah battery packs. They should last 8 hrs talk time with the headsets. This style of battery pack in my experience only last about 1 1/2years and sometimes longer and "sometimes" shorter...much shorter. I bet you never had problems when you first got them. Basicly this "battery design arrangment" goes back many years before newer battery technlogy was developed. But designers still insist on using them even today. They are cheap to make. ****Time to replace them with new ones.**** Make sure you follow the mfgs charging instructions: "After battery installation, place the handsets in their base unit or charger and allow to charge for 16 hours before use. You can keep the battery charged by returning the handsets to their base unit or charger after each use. When the battery is fully depleted, a recharge takes about 12 hours. Average talk time on a fully charged battery is about eight hours depending on environmental conditions, standby time is approximately four days." Good luck