Question about Hitachi 46F510 46" Projection HDTV

1 Answer

The aspect is off

The aspect on my tv is off center and i cant get the picture on the full screen help please

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 927 Answers

Good Day, spaceace33;

Try this:

Symptom: No control of aspect, DCAM may come on by itself, anything other than 480i into component causes rolling and tearing
Cause: Replace I010, This part is a 3.3 volt (micro) to 5 volt (other logic) level shifter HD74HCT245AF, Hitachi part number CK38491R
Hope this was helpful, big IRISH.

Posted on Aug 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ticker along bottom of screen for news channels and sports channels is being cutoff along the bottom. That is, the ticker moves right to left and I can read it but the bottom 10-15% of the letters is...


Hi,

I might need a little more detail to solve this problem - I suspect the problem is an incorrect setting on your cable/satellite receiver (assuming you are using one), but let's start with the TV.

Firstly, switch the TV on and select a channel where you can see the ticker. Then press the "FORMAT" button (above the red REC/CONNECT button) on your Mitsubishi remote control. This will change the screen aspect ratio and the current setting will be displayed on screen. Each time you press the FORMAT button the screen size should change.

The screen aspect ratio settings for your TV are STANDARD, EXPAND, ZOOM, STRETCHED and NARROW. Press the FORMAT button repeatedly until "STANDARD" is displayed on the screen. If the ticker is still cut off, you need to change the aspect ratio setting on your cable/satellite receiver.

Please note: If the TV will only allow you to select STANDARD, this is not a fault. It simply means that the aspect ratio cannot be changed on the TV because it's displaying a picture from an external source, i.e. a cable/satellite receiver.

You should then look for a button on the front of your cable/satellite receiver or the cable/satellite remote control marked "FORMAT" or "ZOOM". When you have located this button, try pressing it repeatedly until the ticker is both fully on the TV screen and the picture covers the entire screen.

If you don't have a FORMAT or ZOOM button for your cable/satellite receiver or you are unable to set the picture size correctly, leave the TV set to STANDARD and then reply to me with the brand and model number of your cable/satellite receiver. I will then be able to assist you with finding the correct picture settings and give instructions on how to set these correctly.

I hope this helps - please post back here if you need further assistance.

Regards,
BElectric

Jan 15, 2011 | Mitsubishi WS-73909 73" Rear Projection...

1 Answer

The aspect ratio of my TV is set to16:9, however on some channels, the picture is not full screen?


That is probably due to the transmission or aspect ratio of a dvd etc and perfectly normal but annoying!
Try setting your TV to automatic aspect ratio, if it has one.
Happy New Year.

Jan 01, 2011 | Projection Televisions

2 Answers

PROBLEM WITH PT61LCX65,PICTURE IS ZOOMED IN AND OFF CENTER


Please check the "aspect button on the remote and select either full ,just or 3 to 4 .......you may also have to chek the "zoom,format or aspect button on your cable or satellite remote as well. I doubt this is a defective tv......let me know!!

Jun 07, 2010 | Panasonic PT-61LCX65 61" Rear Projection...

1 Answer

Screen is expanded to much cant see full picture.


go to factory remote and look for aspect mode and put it on 16.9 or full

Oct 26, 2009 | Mitsubishi Projection Televisions

1 Answer

My Panasonic PT43LC14 is locked in ''FULL'' aspect picture mode. I'm simply looking for a way to do a master reset on the TV. Please help.


Look for button on remote that reads aspect, p size or format to cahnge the picture size. If not there go into Menu and navigate .

Aug 29, 2009 | Projection Televisions

1 Answer

How to adjust aspect ratio on Mitsubishi VS-6043 TV?


I have the same problem and the only thing I could do was to change the name of the input on your tv to pc on the menu screen and it should set it to 1080p reduced this will fit the whole picture and set your screen res on your computer to 1920x1080
hope this helps

Aug 01, 2009 | Mitsubishi VS-6043 60" Rear Projection...

1 Answer

Picture not to edge of screen


That is because you are watching the picture in the 4:3 aspect ratio. This is normal when you are watching a channel that is being broadcast in 480 or digital. But once you tune to a station that has 1080 or at least 720p which is true high def then the picture should expand to 16:9 aspect ratio. It will switch between the two automatically as it determines what type of signal it sees. You can force the resolution to change by pushing the format or aspect ratio button on the remote but you will lose picture quality.

Jan 11, 2009 | Panasonic PT-50LC13 50" Rear Projection...

1 Answer

Can,t get full screen view on TV. Manual says use the WIDE button, but I don't have such on my controller.


The buttom might be labled aspect or wide mode or view mode. If you cant find it you can change the aspect ratio of cable and sat boxs to match the tv

Jan 10, 2009 | Projection Televisions

1 Answer

Model 51f59a hd widescreen aspect settings dont take and picture too big


I called Hitachi and the solution is in your cable remote not your tv remote. Your tv has a aspect menu as does your cable remote. Based on your cable provider you should have a settings or menu button to change the zoom or aspect of your screen. I had the same problem and have Comcast as cable and this worked for me.

Apr 25, 2008 | Hitachi 51F500 51" Rear Projection...

1 Answer

Cant see all of screen


You should have a button or setting on the remote that says "picture size" or "aspect". One of those is set too "zoom" mode which will cut off the bottom and top of the frames. You want it to be in 16:9,Normal or Full mode (or whatever your set call it) to get the correct aspect. Or if you have a HD satellite rcvr. you might of placed it in the zoom mode as well.

Apr 25, 2007 | JVC HD-52Z575 52" Rear Projection...

Not finding what you are looking for?
Hitachi 46F510 46" Projection HDTV Logo

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hitachi Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Hitachi Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...