Frigidaire gas range FGF337

Good Morning M Kinsella, thank you for your inquiry!

Based off the information you have provided your Frigidaire dual fuel range is not igniting on either broil or bake. There is not a pilot light on your range. It typically is an electronic igniter and if it fails that electrical piece would need to be replaced. In order to have that component tested and repaired I would advise seeking assistance from a professional technician. If you do not have a professional contact I would review your manufacturer's website for additional assistance. I hope this is helpful. -Matt

Good Afternoon Friend, this is Z!

I understand you are having trouble with your bake and broil cycles not working on you Frigidaire range, FEF352AWD. You can check and see if resetting the power to your range by either unplugging it or flipping off the breaker for about ten minutes will correct the issue. Should this prove to be ineffective, then the issue may possibly be faulty elements, a communication error with the EOC (Electronic Oven Control) or a wiring issue. I would highly recommend reaching out to an expert technician to ensure the appropriate replacement part is ordered and is installed correctly to prevent future issues. I hope this information helps to some degree - thanks for your question, and please do not hesitate to reconnect.

you can set the amount of time for self clean that you want, you can also turn it off during mid cycle, but if oven is hot it will not unlock the door til it is cooled down enough, maybe 20 min to 1/2 hr. It is a safety pre-caution.

You can replace it or have it repaired to same some cost.

Best Regards,
Bruce
www.fixyourboard.com

Hi,
The ignitor is not working right and is going bad....
have the repair man replace the ignitor, or DIY....
Check out this tip about your problem...

Oven not Working or Oven not Heating
http://www.fixya.com/support/r3663023-oven_not_working_or_oven_not_heating

Oven Problems Replacing the Igniter http://www.fixya.com/support/r4572625-oven_problems_replacing_igniter

heatman101

recheck all the wiring connections to the EOC. Also check for a grounded or shorted element.

This sounds like a weak igniter, it would have to be a gas oven and the symptoms usually are: takes longer than normal to ignite the burner, may or may not smell gas in the oven, does not maintain set temperature or burner does not come on fully, eventually won't heat at all. On gas ovens, a glo igniter is like a light bulb, the more you cook, the faster it wears out. Bottom line, needs to be replaced. Good luck. 

This sounds like a weak igniter, it would have to be a gas oven and the symptoms usually are: takes longer than normal to ignite the burner, may or may not smell gas in the oven, does not maintain set temperature or burner does not come on fully, eventually won't heat at all. On gas ovens, a glo igniter is like a light bulb, the more you cook, the faster it wears out. Bottom line, needs to be replaced. Good luck. 

Check the glow bar ignitor. Is it glowing? If not replace it.

The ignitor should be almost a white hot color very bright . If it is orange or kinda reddish, the ignitor probably isn't getting hot enough to open the saftey valve. you could check the amp draw on ignitor , but most of the time if the ignitor isn't glowing bright almost white , that is probably the problem, besides that if and only if ignitor was good then i would look at the saftey valve. My money is on the ignitor.:)