Cd not coming out..it is running continuously.. button on keyboard not working..! this problem is with studio laptop..no tray provided..!!!!

There are two ways toopen the CD drive door if the button just below the drive tray does not work.
Go to My Computer and right click on the drive and click on Eject.
If this does not work then you can manually open the CD drive tray by -
Straighten a paper clip and gently insert it into a tiny hole below the drivetray next to the Eject button. Push the paper clip gently until the drive traypops out, then pull the tray until it is fully out, then you can remove the CDdisc.
If you continue having problem opening with the Eject button, then the CD driveis faulty and needs replacing.

To eject a disk from the CD or DVD drive when the elect button does not respond, use a straighten paper clip and push it gently into the pin hole int the drive tray. The tray will pop out and you can then grab the tray to fully open the tray.

You can uses the button on the CD drive to eject the CD. If that doesn't work you can also right click the CD drive icon from "My Computer" and select "eject".

I had the same issue with my Dell XPS 15z, after looking every where to get instruction to get the CD out. I decided to call Dell Tech Support and it did work.

1. Turn off the laptop

2. Turn on the laptop and press F2 several times until the setup menu come up

3. Then press the eject botton from the keybord, the Cd should come up.

Good luck

Here is the Dell service manual page where it shows the disassembling of the Dell 1558.
You will have to remove the DVD module to eject the DVD
Procedural steps are on this page site.

http://support.dell.com/support/edocs/systems/studio1558/en/index.htm

Hello there:
This sounds like to me that your cd rom device is going out on you when the disk gets stuck and refuses to come out what you can do is to get a paper clip and sraightren it out now look on the cd rom door and you will see a verry small hole if you press in on the door button and insert the paper clip in the hole when you see the light for the cd rom door turn on press in on the paper clip failrl hard and it will release the locking mechanism and the door will open for you.
you can try to clean the entire tray and the slides tht the tray runs on get some canned air and spray the area really well on both sides and see if this helps
If not that you may want to consider havaing the cd rom drive replaced ok
Hope this is very help ful for you
Best regards Michael

The front of the CD Driver you can see a very small hole…use a safety pin and open it then insert the pin in that hole and push it in that will force the door on the CD to open …Let me know if that work for you and please do not forget to rate my service so I can keep providing this service to everyone and improve on it. God bless

keep pressing the tray of CD. After some time time it will stop there

Studio systems does not have any tray because it uses a slot. Theres no mechanical eject button. You may eject it using the Fn+F10 key on your keyboard.

Supposing that the Studio 15 / 17 has a slot loading drive:

You can either press the eject button above the keyboard (the touch sensitive one)

or

Go to 'Computer' in Vista and right click the CD/DVD drive. Then click 'Eject'.

This should work.