Question about Computers & Internet

Open Question

How to connect korg pa500 with computer through usb port for recording.is there any software or driver needs to be installed.if yes then from where to download it and how to install

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 473 Answers

SOURCE: Should the USB cable be connected when installing USB drivers?

No. Connect the USB cable after the USB driver is installed.

Posted on Sep 06, 2005

Panth3on
  • 71 Answers

SOURCE: CAN NOT FIND SOFTWARE TO INSTALL HARDWARE

here, read this - you should use an ethernet cable to install the router - it is alot easier but here is the manual that will tell you exactly what to do - http://www.buffalo-technology.com/support/getfile/?WBMR-G54+Manual.pdf

Posted on Sep 20, 2007

  • 13 Answers

SOURCE: actiontec gt701-wg Installation

You can use USB instead of Ethernet port but its not a common practise. Leave it empty then.

Posted on Dec 04, 2007

Danmart
  • 291 Answers

SOURCE: need the installation drivers

The Westell 327W (VersaLink) combination DSL 'modem', router and wireless access point will, for most people, be supplied with their new DSL service. Were you using a DSL service and suspended or disconnected? You should still have the drivers in your original computer. If not, the DSL people will install from their side.
I'll keep looking for you.

Posted on May 04, 2008

  • 13433 Answers

SOURCE: 2Wire USB Remote NDIS Ethernet driver

I will look for the driver.

Posted on Jul 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The pitch bend of my Korg pa500 Ort just stopped operating properly yesterday, the problem is that "up & down" is functioning normally but "left & right" is not working (no...


The first thing is to verify that it is supposed to work with a particular performance. NOT ALL voices support modulation as well as pitch bend and with an arranger you can turn this feature on and off, usually in the utility functions and then save the setting for each performance/song. Read you user manual about modulation. On page 271 of your manual they show that the joystick is assignable. You have to assign the functions to the effect you want.

Jul 30, 2011 | Korg PA500 61KEy PROFESSIONAL ARRANGER...

1 Answer

My lcd backlight is very pale, how can I encence the brightness??


Reading your user manual on page 12, bullet 9 you will find the method of changing the contrast of the display. There is no brightness adjustment possible, however the contrast DRASTICALLY affects the readability of the display.

Jul 23, 2011 | Korg PA500 61KEy PROFESSIONAL ARRANGER...

1 Answer

Can I connect my HP all in one device to my computer?


Hi,

Yes you can connect HP Officejet 6210 All in One printer to your PC using USB Cable.
You need the Software to install.
Click on the Download link below to download the printer software/drivers If you don't have software disk.
Choose the operating system to download the software.

Download Drivers


Instructions :

Disconnect the USB cable before Installation of Software
Download the software and run the file to start installation
At a particular point, it will prompt you to connect the USB Cable to PC Port. ( Make sure the Printer is Powered On )
Continue to complete the installation.


* Please rate this solution with Thumbs up and Testimony to help us improve providing support

Dec 16, 2010 | HP OfficeJet 6210 All-In-One InkJet...

1 Answer

How to Restart Korg PA500


System Reset for the Korg PA 500

Jun 28, 2010 | Korg Pa800 Synthesizer

1 Answer

My pa 800 cant link with pc....device driver software was not successfully installed !


Read the installation instructions very carefully.

OFTEN these devices need drivers installed that sometimes must have the USB cable connected, other cannot have it connected while loading.

I have even found some that one has to install while in "safe mode".

ALSO verify that you have the operating system in your computer that is required... Often older software will not work with Vista or Win 7.

May 11, 2010 | Korg Pa800 Synthesizer

1 Answer

MR-1 cannot be mounted via USB


I cannot connect my Korg MR1 to my computer MSI wind with Windows XP via USB port. The computer does not see the hard disk
of the Korg MR1

Jan 19, 2009 | Korg Mr1 Digital Mobile Recorder

1 Answer

Used blackberry


yes you do need drivers to get the computer to recognize the phone.
go to blackberry.com and download the software for your computer.
also dowload the device software.
just to have it
install the blackberry desktop manager and drivers
you should get hooked up then



Jan 19, 2009 | RIM Blackberry 7100i

1 Answer

Need driver for windows to have the Crosley CR249 turntable work correctly.


Hi,
Insert the enclosed software cd into your computer.
Follow the instructions on the computer screen to install the software. If the software does not load automatically, browse the cd and open the Read Me folder for further instructions.
Connect the small end of the USB to the USB jack on the back of the unit.
Connect the other end to a USB port on your computer.
On your computer open the Record Recording software.
For instructions on operating the Record Recording software, browse the software cd and open the Read Me folder.

I got that from the manual. You don't need a separate USB driver for it, mate, but you DEFINITELY need the cd...

Hoping you have the cd,

Chris (ziraffa)

Dec 28, 2008 | Crosley CR249TA Turntable

1 Answer

Can I transfer to my computer?


This IC Recorder doesn't feature the USB port. However, you can transfer the files by connecting the Headphone OUT of the IC Recorder to the LINE IN of the Computer. Then, use any Sound Recording Software. You can also use the Sound Recorder Software that is pre installed in the Windows Operating System.

Jun 09, 2008 | Sony ICD-B25 Digital Voice Recorder

2 Answers

2488 as an interface


yes if usb connection

yes if you can connect line in line out connection

yes pararlell port connecting

May 07, 2008 | Tascam 2488 Portastudio Multitrack...

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

337 people viewed this question

Ask a Question

Usually answered in minutes!

Top Computers & Internet Experts

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

kakima

Level 3 Expert

102366 Answers

David Payne
David Payne

Level 3 Expert

14161 Answers

Are you a Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...