Question about Fujitsu 24C1 Air Conditioner

1 Answer

Fujitsu split level

I installed 2 units 1 of the units is blowing air from the inside but fan on outside unit will not kick on checked wireing every thing looks ok, can't be weather cause one unit works fine tried to jump wires to turn fan on automatically now nothing works any ideas thanks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 236 Answers

Check for errors like blinking indoor light if present. Reset the error by disconnecting power supply from the unit for 10 sec. and "on" the unit. If the error persist, some parts of the unit may be defective and need to replace. Like room air thermistor, coil thermistor in the indoor side or the relay board. Some safety device in the outdoor may give in, some outdoor parts may be defective. You need a qualified technician for the this problem.

Posted on May 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My air handler fan does not come on, the outside unit turns on fine. Is their a way to reset the fan?


Check for fan operation by turning the fan control at the thermostat to "on". If the fan blows, it works. If not, check a circuit breaker or fuse.

If the fan blows when forcing it on with the thermostat but not in automatic, check the fan control circuit in the air handler. Danger: high voltage, beware! There should be a system wiring diagram inside the air handler somewhere.

Mar 30, 2014 | Rheem 4 Ton Air Handler - RHLLHM4821JA

1 Answer

My Fujistu AST9LSACW split system air-conditioner wont blow cool air. the outside unit AOT9LSAC doesnt seem to be working at all. The power light stays on but the timer light flashed about 15-20 times a...


There are two things you can check outside before calling a service technician. The first is the breaker to the outside unit. There is a breaker or disconnect near the unit. If there is nothing wrong with the electrical supply, check the refrigerant level. If the level is low, the pressure switch will cut off power to the compressor to protect it from damage. DO NOT try to recharge the compressor yourself.

Jan 30, 2011 | Fujitsu Air Conditioners

1 Answer

My fujitsu inverter asta12jcc outside fan is not working. On the inside unit the operation light is on for a few seconds than the green timer light flashes every few seconds. but the fan inside is running.


Communication error between indoor to out door.Comms Error, check your wiring, remove external pumps. Split/Multi - check volts from terminal N to 3 = 0 - 65 Vdc, Multi V - 4 Vdc terminals 3 and 4

Jan 02, 2011 | Air Conditioners

2 Answers

The air conditioner is pouring water on the floor!


Sounds like your water drain line is plugged. There should be a bundle of wires tubes and a drain hose that goes through the wall to the outside unit. The water drain hose should split off outside and drain on the ground. You should check that the drain hose is not plugged or kinked somewhere. The hose must also slope downwards from the inside unit to where it drains outside. You can check if the hose is plugged by blowing into it if you can reach the hose outside. You should be able to easily blow through the tubing back into the house. I have done this with this type of unit at night (determined to get it working), and was able to get it to start draining properly. Before I got it to start draining, I had the same waterfall that you are seeing. The unit had been off all winter. Hope this helps.

May 23, 2010 | Fujitsu 24C1 Air Conditioner

3 Answers

Split unit, I get heat but no cold


I have run into this with the LG brand systems. try shutting power off to the outdoor unit to reset all units. If problem persists, it could have to do with a charge level of refrigerant (freon) or possibly a failed control board.

May 16, 2009 | Fujitsu 24R1 Air Conditioner

1 Answer

Will Not Heat


On the outdoor unit the fan should not be running, on the indoor unit the fan should be running. If you then check the outdoor unit with fan not running, you should be able to hear clearly that the compressor is actually working. If this is all correct, it is possible that your fourway reverse valve is seeping and needs to be replaced.

Apr 15, 2009 | Fujitsu 18R1 Air Conditioner

1 Answer

Fan coil unit won't cool or heat in room1 while room2 runs well


could be undercharged, or overcharged, or wires weren't put back on valves in unit.

Feb 16, 2009 | Cfm Daikin R410a Split System Air...

1 Answer

Air conditioner not geting cool


Hello, It sounds to me like your low on freon/refrigerant. You'll need to have someone test the pressures for you.

Jan 24, 2009 | Fujitsu 24C1 Air Conditioner

Not finding what you are looking for?
Fujitsu 24C1 Air Conditioner Logo

304 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fujitsu Air Conditioners Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

BOB  BROWER
BOB BROWER

Level 3 Expert

267 Answers

Bill Long

Level 3 Expert

577 Answers

Are you a Fujitsu Air Conditioner Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...