Question about Saeco VIA Venezia

1 Answer

"No water" & "No Beans" lights are on.

There are beans and water in the containers, but the above lights are on. Nothing else works except the steam supply. No pump, and no grinder. Both were working when I had the top cover off to dismantle the grinder blades for cleaning. Grinder worked fine after that until I repfitted the top cover.

Posted by on

  • Pickster Jul 17, 2008

    Machine type is Via Venezia SUP002EV. Thank you!

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 515 Answers

Hi,

What kind of machine do you have, there will be a type number on the machine like SINXXX, SUPXXX

Posted on Jul 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Grinder spins. Hopper is full of beans. Why is no ground coffee dispensed?


You will probably find that the grinder is bunged up with grounds. This can happen if there is a bit too much steam inside the housings. The grounds bind together and will not drop with gravity. Pull the grinder apart, clean it out then run it with the top housing off and see if you can observe any leaks/steam. There will be some steam, you are looking for excessive steam.

Sep 13, 2015 | Miele CM 5200 Espresso Machine Black

1 Answer

RE: F9 Upon startup the unit goes thru the normal cycles for making an expresso but, after the beans grind, little to nothiing is dispensed. The unit stops and the message is to fill water portion. I push...


Hi Bill
What happens when you do a tea ? (hot water only, NOT the steam button) do you also get little water ?
The fact that you are getting steam is good as there are 2 heating systems in the unit.
Have you ran the descaling recently (if you do not use filter ) ?
If you have or use a filter the problem is likely to be at the rear of the machine, however the back contents all the power and you will need to be happy to do some stripping down of the machine,
In the back you have the pump, valves, heater etc.
I am just about to draw up a flow chart of the water system inside the machine and have it published online (couple of days).
Are you happy to strip machine down ?

---


Please dont forget to vote if you liked my answer


thanks

------




Feb 12, 2011 | Jura Capresso Impressa F9 Espresso Machine

1 Answer

Hi, my tchibo coffee machine display is showing bean container empty when the container is full of coffee beans.I have removed the container and made sure it is there is nothing obstructing the tube.i have...


Hello

Push "Off" on the coffee maker's control panel. Unplug the coffee maker, and allow the machine to cool down completely. Remove the coffee bean container by lifting up on it and sliding it out. Wipe it out daily with a damp cloth, and slide it back into the coffee maker. Press down on the handle to click the container into place.

Dump out the water in the water container,Wipe out the water container with a damp cloth. Refill the water container with clear drinking water.

Remove the dump box and drip tray, and empty them.Wipe each one down with a damp cloth. Open the service door and push "Press." Remove the brew group by its handle, and rinse if off in a sink with hot water. Use the key provided to unscrew the plastic pin holding the metal filters together. Rinse each one separately. Put the filter back together and dry the separate parts with a towel.

Mix a package of descaler with the water in the water container every four to six months to rid the coffee machine of mineral deposits. Plug in the coffee machine, and select "On." Select the "Hot Water" button, and position the steam valve over the drip tray. Dispense two thirds of the descaler and water into a container in 15 minute intervals by turning the steam valve counterclockwise to dispense and clockwise to shut off the flow.

Let the coffee machine heat up fully, and then dispense the remaining descaler and water by turning the steam valve counterclockwise to empty the water container. Press "Off" to turn the machine off.

If this does not work then you might require a technician.

THANK YOU FOR VISITING FIXYA

Feb 10, 2011 | Coffee Makers & Espresso Machines

1 Answer

My machine blinking on steam, the wand does not want t o steam, the espresso does not pour. The knob is turned on stand by , but still some steaming noise comes, but no steam comes from the wand, nor...


When it is blinking on steam it means it is preparing the unit for steam. When the steam light goes solid your unit is ready to make steam.

  • Turn from standby to steam then wait for steam light to go solid.
  • When solid steam wand will begin dribbling then spitting out water, which will then turn to steam.
  • When it begins to steam, turn back to standby. NOTE: you only have 6 seconds before steaming turns off.
  • place steaming wand in jug and turn from standby back to steam.
You will hear pumping noises when you turn off your steam, because it releases the steam and puts the excess water in to the drip tray.
  • make sure your bean hopper is properly locked in to the unit. Grinder won't work if hopper not locked in.
  • Make sure your water filter has been prepped and locked securely in to the reservoir and your reservoir is filled.
  • Use fresh beans.
  • Sounds funny but use good quality water, do not use ordinary tap water. Make sure it is filtered or use bottled water (cooler bottles).
  • Try to grind your beans to a good consistancy.
  • Breville recomends about 10kg tamping pressure, use a set of scales to check the feel.
  • Tamp to about 3-5 mm below rim of grouphead (portafilter). Or the tamp has a guide on the side, that silver side on the tamp is the tamp line. Pretty vauge about that in the book.
If all else fails go to www.breville.com.au and check your model and watch some of the vid clips.

Jan 06, 2011 | Breville Fresca BES860 2Cup Coffee Maker

1 Answer

Water on top of the filter after brewing


my experience with this machine is that this varies greatly with the type of beans you use. I would experiment with a few types of beans, roasts, and you might get lucky.

Nov 28, 2008 | Breville ESP8XL Espresso Machine

2 Answers

Saeco magic comfort coffee machine grinder


Hi,

Make sure you not get any water in the grinder, if you got water in the grinder then you have to clean it.

You can try to set grinding to coarse and try to make 3 cup of coffee.

Jul 22, 2008 | Saeco Magic De Luxe Espresso Machine

3 Answers

Saeco Italia SUP021 YR - Red light #29 on solid


Not clear on "Empty bean container/full grounds drawer) - not empty/not full. " But I gather that coffee is not being dispensed. Most Likely the grinder needs cleaning + brew group needs cleaning ( filter ). Do you get water/steam?

Jun 10, 2008 | Starbucks Saeco Italia Digital Barista...

1 Answer

Saeco Vienna Deluxe


ok which red light are you talking about. the water or the beans or the warning

Apr 15, 2008 | Saeco Vienna De Luxe Espresso Machine

1 Answer

Coffee Grinder not working


the grinder is most likely stripped and needs to be replaced:-{

Jul 23, 2006 | Saeco Caffe Charisma Espresso Machine

Not finding what you are looking for?
Saeco VIA Venezia Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saeco Coffee Makers & Espresso Machines Experts

Ernest R
Ernest R

Level 3 Expert

1618 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Ray Murphy

Level 2 Expert

67 Answers

Are you a Saeco Coffee Maker and Espresso Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...