Question about Dryers

1 Answer

Dryer shuts off after a few minutes

10 years old. Dryer got noisier. Now shuts off after a few minutes. Will not start again until hours later and will run for just a few minutes. Had high limit thermostat replaced 11 months ago when dryer ran but with no heat. Part is still under warranty but service call will still be charged.

Kenmore 80 series gas dryer model 77832

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

THE KENMORE DRYER I HAVE... IF REN IN THE COTTON CYCLE IT WILL RUN FOR 50 MINUTES AND SHUT OFF. ITS BOLWING HOT AIR AND THE OTHER CYCLES SEEM TO WORK FINE WITH OUT SHUTING DOWN SO ID APPRECIATE A TIP ON WHAT THIS PROBLEM COULD BE

Posted on Nov 02, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I took my dryer apart and found a staple on cushion of barrel. I did not remover circuit board and may have damaged something. When torn dryer on the timmer light shimmers and will only dry for 30 mi


sounds like u may have a motor winding going bad will usually run 20-30 minutes then shut off and if u run agin right away it will run 10-15 minutes and shut off agin. run an hour later and u will get 30 minutes or so agin? or u may have bad venting causing an over heating prob

Oct 28, 2014 | Maytag MDE2400AYW Neptune Electric Dryer

1 Answer

Dryer starts up runs for a second and stops a few minutes later starts up runs a second or two and stops


Dryer runs then shuts down wont start up for an hour:
Bad motor windings

Oct 05, 2014 | Amana Dryers

2 Answers

Dryer starts then stops 10 seconds later for 1 minute then starts again


You dryer has several "overheat thermostats" located at various places inside your machine.
They are to prevent fires caused by overheating.
I suspect one of them is defective, or you have another problem which is causing one to shut your dryer off.
The dryer is shutting off to prevent a fire.
Be blessed

Feb 08, 2013 | LG DLE2532W Electric Dryer

1 Answer

Hello, my 55513 tv when turning it on was blurry. after a few minutes it became clear. shut off and came back about 3 hours later and it was blurry again for about 10 minutes. about 10 minutes later it...


in the customer menu select convergence when set acts up---look to see if grid of lines is skewed, see some photos and let me know if your problem anything like this..........
4_8_2012_1_08_59_pm.jpg4_8_2012_1_09_27_pm.jpg


4_8_2012_1_10_19_pm.jpg

Apr 08, 2012 | Mitsubishi WS-55513 55" Rear Projection...

1 Answer

Turns off after a few minutes


sounds like your motor is overheating or going bad. sometimes lint built up around the motor can cause it to overheat. or the motor is dying.

Aug 31, 2009 | Kenmore 73952 Gas Dryer

1 Answer

Furnace runs OK, but blower runs again a few seconds later


Could be a defective thermostat in the plenum.
When a gas furnace shuts down the fan(blower) will run until the plenum cools to the safe range. Usually 1 and 1/2 minutes.
Intermittent operation is a defective thermostat or relay.

Mar 11, 2009 | Carrier Heating & Cooling

1 Answer

Sears 19 hp twin 42 inch tractor, won't start if hot


Hi
Two things come to mind. First it could be not getting enough fuel when hot due to carb adjustment being too lean. That could be that the float level in the carb is set too low or the low speed jet is set too lean. When cold the choke circuit in the carb supplies the extra fuel required.
Second in some enjines that have low compression they start cold but when hot the compression drops below 60 psi and makes starting very difficult until engine cools down.
I suspect a fuel problem.

Nov 25, 2008 | Craftsman 17.5 hp 42 in. Deck Lawn Tractor...

1 Answer

Shutting off and on...


the problem may be due to dry soldering in the power supply stage if it was with the lamp there would be red or green light showing the presence of the power to the tv after making it own some of the components get hot and it will make the the soldering point conectionless and after some time the heat sink get cooled and the soldering point gets connected and u will see the picture again it is a simple problem if u have a soldering iron u make it hot and re solder all the components in the first part of the circuit board and the problem if rectified

Jul 03, 2007 | LG RU52SZ30 52" Television

Not finding what you are looking for?
Dryers Logo

Related Topics:

853 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dryers Experts

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

yadayada
yadayada

Level 3 Expert

71231 Answers

Brad Brown

Level 3 Expert

15220 Answers

Are you a Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...