I just bought a new yellow ink cartridge, and when I put it in the printer says that the yellow ink is depleted. I changed the ink two times. What should I do?

you will have to get 4x new color chips. and replace it on the cartrdges

I have a Canon Pixma iP4300 printer and the Yellow ink is not printing. I have changed the particular cartridge and all other colours are working except Yellow. I have cleansed the printer several times and tried with new Yellow ink cartridges with new chips, but nothing helps.
What should I do?

I would change the ink cartridges for yellow and purple inks to start. If the other ones are depleted also change those.

http://www.fixya.com/support/r3845491-ink_cartridge

Check out there FIRST befoe you get into things too deeply

A lot of common tips that tend to help a lot of people.

Bob

I had the same problem with mine but I bought a refill cartridge instead of a new one and went through three refilled cartridges when I found that it was that I needed a brand new one. For some reason, the HP printers and some other printers need to know that you are using the same brand of ink as the printer. if it is another brand it wont except it and it wont let you print anything! So make sure it is a brand new hp brand ;)

I thru out an epson ink jet and never bought one again. I did not use it that much and the ink dried in the head and it would not clear out.
I toke it apart and soaked it is almost all the solvents from dish detergent lye for denatured alcohol to napa tested it each time and nota so save the frustration buy a new head or a printer instead. where anytime you place new ink the heads are changed too.

Solution Replace the indicated ink cartridge(s), or press OK on the control panel to continue. HP recommends the use of genuine HP ink cartridges. Genuine HP ink cartridges are designed and tested with HP printers to help produce great results, time after time.
NOTE: HP cannot guarantee the quality or reliability of non-HP ink. Printer service or repairs required as a result of printer failure or damage due to the use of non-HP ink will not be covered under warranty. Follow these steps to replace the depleted HP ink cartridge(s). Step one: Replace the indicated cartridge(s)

1. Make sure the HP All-in-One is turned on.
   NOTE: The Attention light blinks when the product is turned on.
2. Open the access door by lifting from the front center of the HP All-in-One, until the door locks into place. Figure 1: Opening the access door
3. Squeeze the bottom of the latch below the ink cartridge to replace, and then lift the latch.
   • To replace the black ink cartridge, lift the latch on the far left.
   • To replace one of the five color ink cartridges, such as yellow, light cyan (blue), cyan, light magenta (pink), or magenta, lift the appropriate latch in the center area.
   Figure 2: Lifting the latch 1 - Ink cartridge latch for the black ink cartridge 2 - Ink cartridge latches for the color ink cartridges
4. Pull the ink cartridge towards you out of its slot to remove it. Figure 3: Removing the ink cartridge
5. Remove the new ink cartridge from its packaging.
6. Holding the new ink cartridge by the handle, push the ink cartridge into the empty slot. Match the color and pattern of the ink cartridge to the color and pattern on the print carriage. Figure 4: Inserting the new cartridge
7. Close the latch, and make sure it is secure.
8. Close the access door. Figure 5: Closing the access door

Step two: Align the new ink cartridge(s)

1. Make sure paper is loaded in the input tray, and then press the OK button. The HP All-in-One prints the alignment page, aligns the printhead, and initializes the ink cartridges. This takes approximately 5 minutes. CAUTION: Do not disconnect or turn off the HP All-in-One during this time. You may hear the HP All-in-One making noises.
2. Check the display for status, and then press the OK button. Recycle or discard the alignment page.

Cause The original HP ink in the indicated ink cartridge(s) has been depleted.

Please don't be offended if I ask that you carefully check whether you have removed all packaging
of the cartridge, including the ink seals on the heads of the cartridges you have supplied. Believe me,
this is a VERY common problem, and given your elimination by purchase of two additional cartridges
is more likely your problem than defective cartridges, assuming that all such yellow cartridges are not
DOA at FOB.

pulled plug, removed yellow cartridge, cleaned point where yellow ink goes in, put plug back in and it worked.........Thanks

i got something like that too .. it was my yellow ink which was doing it ... at a point i was so fed up that i put another blue cartridge and you know what .. it works ... so it means that the brand new yellow that i bought before was not even good !!! WOW .. way to go Brother !