Menu screen keeps coming up all the time. sometimes I can exit, sometimes not. Very frustrating. Can't seem to control it.

What you are describing is a hard drive issue, remove hardware and reseat it back in place sometimes this will restart the hard drive. If this fails have it tested.

You have to contact the authorized service provider as this fault
seems to be on the control processor.

Or check the menu and try to disable it. Scroll through the options.
Try looking patiently! Finally call the service provider, if no alternative.

in your monitor paenl tehre are button like menu and enter and up and down arow just press the menu button twice or turn off the monitor and switch it on .

It means that some kind of parental control feature has locked you out of the On Screen Display menu. You will have to consult your manual (possibly online) to figure out how to reset the password.
Although it is possible some other kind of malfunction could cause you to lose menu control, this is the most likely cause.

Sounds as if the "menu" button is making intermittent contact. Try spraying it with an electronic solvent (available from most Electrical/Electronic outlets. e.g. RS Components) and press it many times (Power off!). This may rid the button of any gunk in there.

never try to fix crt monitor you need a new one cos thay are so cheep cost you lots for reppers ,bye an lcd ,,,,nice

the tv wont come on the standy timer light is on

It seems that ur control panel on the monitor having some problem...U need to take it to service center....

When I turn on my TV it goes straight to the menu screen. You can still hear sound but no picture. When I try to exit you see the picture for about a second then it automatically flashes back to the menu screen. Even if I try to use the functions in the menu screen it flashes right back to the main menu screen. Very frustrated...need help!

It sounds like theres a front panel button that has become intermittant and making contact all by itself. Sometimes when you clean the screen, the cleaner will drip down between the crt face aqnd the cabinet and make the switch in front go bad. Im not sure if this is the case in your problem but its a start. If you didnt spill anything or drip anything into the front panel then your maicroprocessor could be causeing the problem, or the 5 volts that feed the micro could be noisy ie, bad filter capacitor in the power supply. Now as im sure your aware of the hi voltage inside these sets? Its best if you dont have the training to get a pro to assist you as this hi voltage can hang around inside the set even if its unplugged. Good Luck