Question about Minolta DI-2010F Copier
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: error message C0500
Take a paper clip and unbend it. Then stick it in the small hole on the right side of the control panel. The machine will say please wait. after a few seconds you will see a small blue dot appear on the left side of the contol panel, (about middle of the screen) when you see the dot press the down the "3" button a screen will appear, select "Trouble Reset" once done machine will go thur its normal procedure. Once you have ready to copy, turn off the machine agian and turn it back on, if you don't the start button will be flashing continuously, If code comes back then the fuser is shot (Fuser is the hot section of the copier. which fuses the toner to the paper.
Posted on Jul 19, 2009
2nd Drawer Lift-Up Motor Failure - The Lift-Up Sensor is not unblocked even after the set period of time has elapsed after the paper liftup operation for the drawer has begun.
Reset your Toners and Imaging units for Bizhub and CF series.
Posted on Nov 27, 2009
You have a problem with the fusing unit. This is the assembly that gets hot and "fuses" the toner onto your paper. This error code means that the fusing unit did not warm up properly. You will need to have a service company come out to diagnose and repair the problem then reset this code as service mode entry is required in order to reset. It could be as simple as cleaning the thermistor, replacing the thermistor, thermal fuse etc. I would estimate the cost at around $200.00.
Here is the section from the service manual that deals with this code:
Thermistor /1 (TH1) detects a low
temperature when a specified
period of time elapses after the
fusing heater lamp is turned ON
for the fusing ON control.
Posted on Jun 09, 2010
Tips for a great answer:
Apr 01, 2016 | Konica Minolta Office Equipment & Supplies
May 28, 2014 | Konica Minolta bizhub 350 All-In-One Laser...
Jan 21, 2014 | Konica Minolta PRINTING - Bizhub-250...
Feb 08, 2010 | Konica Minolta bizhub C351 All-In-One...
Mar 23, 2009 | Konica Minolta bizhub 350 All-In-One Laser...
Jan 10, 2009 | Konica Minolta bizhub C250 All-In-One...
Mar 13, 2008 | Konica Minolta bizhub C351 All-In-One...
Mar 03, 2008 | Konica Minolta bizhub C250 All-In-One...
134 people viewed this question
Usually answered in minutes!