Strategy spin saw model V17279/manuals - Dremel 300-N/55 300 Series Tool Kit

http://www.fixya.com/support/t11233607-mastercraft_maximum_spin_saw_kit_manual


At one time, no manuals online.

Hard to find a reference using Google.

Hi Carol.
try this link for the manual.
Manual for strategy spin saw model v17279 Google Search

I don't know the make or model of your saw but the blade brake on circular saws is controlled by the power switch. If your saw previously did brake the blade rotation, you need a new switch to make it work again. Also a generic switch will not do, you have to have the brake switch made for your saw or it will do the same thing.

CHANGE THE BEARINGS AND LOOK IF THE WHELL IS BEND OR LOOPED.

Unfortunately, this is common on older model table saws. They do not have a blade brake and as far as I am aware it is nearly impossible to retrofit them.
If this is a newer model saw it's likely that the blade brake is malfunctioning and I have no experience with them.
Hope this helps and am very sorry if it doesn't.

Ken

The gears are stripped internally in the saw...it will need to be repaired..

heatman101

need manual on strategy spin saw.

First, there is no blade lock button on the Skil model 5150. I called the Skil customer service and they emailed me the exact manual for this circular saw. The method I used to loosen a VERY TIGHT blade stud was: spray with WD-40, imbed the blade in scrap wood, set Skil wrench (usually found in back of foot under handle) on so it could be struck going in counter-clockwise direction. Use hammer to strike handle of wrench a couple of times. To replace blade, finger-tighten blade stud, then use wrench to tighten 1/8 turn or (45°).

It sounds like the pinion on the armature and or gear are stripped. The only way to find out is to tilt the blade and remove the motor housing from the diaphragm and check it. If replacing the armature I would recommend also replacing the bearings and brushes as preventative