F1 appears on washer dial must push stop and start several times to start wash cycle. Also same to start rince cycle

Cleaning washer filter


Whirlpool Washer Diagnostic Repair F1 Error Code WTW6400SW2

spin dial oround 3 times to rince, then start new cycle

You have an issue with the controller on your machine. Needs replacement.

It is either a bad control or a broken wire.


Oasis manaul

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

I too was having the same problem and I almost paid to have it repaired, which would have cost a few hundred dollars, thanfully I called the recall line after reading some of the other post on here and my machine was elgible for a upgraded on the control panel so didn' t cost anything for us. Sears told us that the F1 code is a miscommunication in the control panel, basically the machine is confused and don't know what to do so it stops and gives that code. Hope it helps!

this is a main control board failure and needs to be replaced

call mfg. i heard they are fixing this problem even washer is out of warranty. to solve this problem your washer need new control board.

Sounds like the contacts in the timer has a problem. Unplug washer. Remove the back of the washer and spray WD40 in the timer. Put towels around and under to to collect excess runoff.
Rrotate washer dial 25 times and spray some more wd40. Rotate 25 times again. Do a wash load. If it works put everting back together.

Washing machine stops at the spin cycle - light flashes. Have to drain water out manually. Happened last week and was then able to run an empty rinse cycle. Machine worked normally for another week. Same problem today but have had to drain water manually from the drum after trying an empty 90 wash and rinse cycle (both stopped on the Spin and flashed). Any ideas? Thanks. x