Question about Scytek 2000RS Remote Control

1 Answer

Car Alarm Instructions

I Need The Installation to My Car Alarm It Is A Galaxy Model # 2000RS

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Go to scytek.com you can download there

Posted on Jul 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

No instructions for installing car alarm


hello guys i bought a nitro 422bmw 2-way alarm system and i didnt get the manuanl for this alarm system , the code for the this alarm system? can you please help with this solution? my name is joey? thank you guys

Jul 29, 2009 | Scytek 2000RS Remote Control

1 Answer

Don't know how it works.


manual for the system can be found at scytek.net

Apr 30, 2009 | Scytek 2000RS Remote Control

1 Answer

The doors lock when I start the car - I don't want that!


the unit can be programmed to lock the doors after starting, to make it leave it alone you have to enter the programming(ignition on, press the valet switch 5 times within 5 seconds, the lights will flash 3 times to signal you have entered programming, then press valet switch 10 times(lock after start setting) within 5 seconds hit the unlock button on the remote (button closest to the side with the other buttons)
then turn off the ignition to save the settings and it should be done

manual for the system is found at scytek.net under the download section

Apr 14, 2009 | Scytek 2000RS Remote Control

1 Answer

Galaxy remote start wont do anything.


i just fixed mine.. under your dash look for the immobilizer switch box/plug...the red light should be lit, unplug then plug back up again (reset it)...you should be fine after that.

Mar 09, 2009 | Scytek 2000RS-M Remote Control

1 Answer

Galaxy 2000RS-M not working


sounds like a defective remote, you can find new remotes for the starter on ebay ,

the manual can be downloaded from scytek.net

Dec 13, 2008 | Scytek 2000RS Remote Control

1 Answer

Timer in auto start.


if it is the 2000 rs the manual can be downloaded from scytek.net

1. Turn on ignition.
2. Within 5 seconds, press the valet switch 5 times.
· The parking lights will provide three blinks, indicating that you have entered Programming.
3. Press the valet switch 12 times (engine run time)
· The parking lights will flash each time the valet switch is pressed.
4. Within 5 seconds, press the transmitter button corresponding to the desired time ( left button 15 min, right button 25 min)
· The parking lights will flash to indicate the setting.
1 flash = 15 min
2 flashes = 25 min
5. When you are finished, turn off the ignition to save the changes.


all of this is based on that it is the galaxy 2000rs m,

Nov 19, 2008 | Scytek 2000RS-M Remote Control

1 Answer

Galaxy 2000 Rs-m


yes, you can connect the tach sense wire from the controller(2000rs) to a fuel injector , and select tach monitor in the programming (see manual, available at scytek.net) and it will automaticcally adjust the starter crank time, other way to go is to install a delay card, sutch as the k 141 multi mode timer, and set it to crank for 3-6 seconds when triggered

May 26, 2008 | Scytek 2000RS-M Remote Control

1 Answer

Dont have manual for installing car alarm


go to scytek.com you can download it ther

May 10, 2008 | Scytek 2000RS Remote Control

1 Answer

Dont know how to work it


do not lock doors with facory switch it is setting the factory alarm must shops dont get the factory disarm alarm wire to shut it off.this will always happen use the remote with the remote starter to lock and unlock doors and it should be fine

Mar 28, 2008 | Scytek 2000RS Remote Control

1 Answer

Galaxy 2100RS


if this vehicle has a white wire in the ignition harness it needs powered by the ignition out of the remote start if your remote start doesnt have a second ignition use relay not poering this wire will ruin your transmission the white wire must have power this should solve your problem dont use remote start until you fix this problem or it will cost alot of money.

Mar 13, 2008 | Scytek 2000RS Remote Control

Not finding what you are looking for?
Scytek 2000RS Remote Control Logo

Related Topics:

256 people viewed this question

Ask a Question

Usually answered in minutes!

Top Scytek Remote Controls Experts

The Knight
The Knight

Level 3 Expert

68229 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Cindy Wells

Level 3 Expert

4755 Answers

Are you a Scytek Remote Control Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...