I have a question on the pionner avic z2 ilike to by pass i allready trae to by pass it chang it the wires from the back and im driving like 20 miles and the movie is goone go to lack mode please sand me info wat i need to do tank you please email me at vg perez [email protected]

Reset the unit and begin with the setup screen to change the language.

to watch dvds without you having to be in park you have to rewire the wiring to the deck. not the speakerwires or anything like that there should be a pink or orange color wire that comes from the harnest of the back of the deck anyway that wire is the only single wire in its own color besides (red yellow black) these are the wires that give power to your deck. all u have to do is take that one wire left over i think its orange in color and ground it (connect it with the black wiring. that should bypass the brakes from the deck n ypou can watch dvds as you drive but dont forget to also watch the road. :)

your blue wire(power antenna) is connected to your factory amp. this wire only sends out audio when the radio is on(power antenna)
disconnect this wire and hook up the blue/white instead
problem solved
Kieran

i'm trying to install the avic z2 and the display say starting navigation sistem and it does not disaper am i doing something wrong

There is a firmware update that solves the Freezing issue.
SEE THIS LINK for additional help and downloads from Pioneer.

Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question!!

The rick to cure this problem is to disconnect the ground wire from the harnessand ground it to metal on the vehicle like ashtray or something. (radio ground to car metal. This will cure your problem

Heres a good site that has alot of bypass guides for Pioneer Avic Units

http://underground-secret.com/avic_n1_bypass.html

Pioneer Avic D1, D2, D3, N1, N2, N3, N4, Z1, Z2, Z3, F700BT, F900BT & F90BT.

change the positive from the xm module to the other poisitve wire grom car and that shpuld do it

My solution is a bit primative but it will work. Beside grounding your brake wire you need to cut and build a switch on your gps antenna. When you flipped the switch off your gyro sensor does not know that you are in motion then it will allow you to watch video and when you want navigate just simply flip the gps antenna back on. Becareful and leave enough lenght between anteenna and connector and remember to insulate all spliced wires to prevent shortage. Let me know how it goes. Goodluck.

I installed my pioneer avic z2 DVD/Navi myself and I realized that the wire that connects to the parking break is just a power wire that comes on when u pull the parking break. I think, all you have to do is to connect it to any other power wire that will be constantly provides the on power while driving. I'll try it out tomorrow and let you know!