Question about Delta Faucet Delta 470-BL-DST Signature Single Handle Pull-Out Kitchen Faucet With Spray

1 Answer

Facet still leaking after replacing the RP4993G part.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Make sure the area below where you replaced that part is free of scale and is not damaged in any way. Scuffs, scale and dirt will caused your leaking.

Posted on Sep 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change out copper piping from release valve


If the release valve referred to is the pressure release valve, then a water leak out the attached vent pipe is an indication that the valve is failing. To change the valve, the water must be allowed to cool (turn off AC power or gas) and the water level inside the tank must be lowered (drained) to below the level of the pressure relief valve. Once this is accomplished the vent pipe is unscrewed from the relief valve and the pressure relief valve is unscrewed from the water tank. A new pressure relief valve with a sealant on the threads, is then screwed and tightened into place with the outlet port facing downward. The vent pipe is attached to the new valve and the tank refilled with water. A hot water facet must be opened to allow air to exit while filling. Upon becoming full (water will begin to flow from facet), turn off the facet and restore AC power or gas, therefore allowing the water heater to heat up. When the first hot water is utilized there may be some air expelled from the facet.

Sep 13, 2015 | Water Water Heaters

1 Answer

Wiggling Goose Neck


There could be loose hardware inside at the base of the goose neck. You will have to remove your carefully installed faucet and take a look inside to find out.

Nov 13, 2013 | Globe Union Glacier Bay 8 In Double Handle...

1 Answer

Delta 18 series tub facet leaks


the possible cartridges you can replace are listed on this pdf
http://www.deltafaucet.com/media/SpecSheet/DSP-B-R18000_Rev_A.pdf

Jan 13, 2013 | Delta Innovations 18 Series Monitor...

1 Answer

Facet leaking


Hi,
You can purchase a replacement cartridge for that... most hardware stores or places like Home Depot or Lowe's will have them. Take in the old acrtridge or the model of thefaucet. Some of them need a special puller to get the old cartridge out..

heatman101

Jul 11, 2010 | Moen & Villeta Two Handle Lavatory Faucet

1 Answer

Hot watwer leaks from the hot side of the facet


Replace the stem assembly (ceramic cartridge) with Price Pfister service part #910-030. Be sure to turn water on briefly to flush out any debris in the valve body before installing new part. NOTE: this valve does not like old galvanized plumbing.

May 21, 2010 | Price Pfister 01-31xa Shower Head, Tub...

2 Answers

Leaking form shower facet also leaking from


id say your tub spout or shower pipe is leaking and running down behind remove both and replace teflon tape see if it stops

Mar 14, 2010 | Home

1 Answer

Mixet single control shower facet leak


did you replace the seats and springs too? if not this may fix your problem.

May 28, 2009 | American Standard 2385.003.002 Reliant...

1 Answer

My Danze Anu Kitchen Faucet


Sounds like you have hard water.  You need to change the inside of the facet.  before doing anything make sure you CAN get the parts for you facet.   Danze are not very expencive you might just get a new facet.  If this is a hard water problem you might want to buy a moen facet with a life time warrinty.  More money but free replacement parts.

Apr 04, 2009 | Plumbing

1 Answer

Grohe kitchen facet 33 759 clogged


check the airraider on the spout of your faucet it unscrews and can build up with junk and sadly some times sediment works its way in to your faucet and clogs the stems and with a grohe faucet being as pricey as they can be i sugest replaceing the stem as aposed to getting another grohe faucet 

Mar 28, 2009 | Plumbing

1 Answer

Leaking Delta bathroom facet


Is this single handle?If so, you need a allen wrench to take handle okk.But come to think about it you get the tools with the repair kit.

Mar 13, 2009 | Plumbing

Not finding what you are looking for?
Delta Faucet Delta 470-BL-DST Signature Single Handle Pull-Out Kitchen Faucet With Spray Logo

340 people viewed this question

Ask a Question

Usually answered in minutes!

Top Delta Faucet Plumbing Experts

Donni Steen

Level 3 Expert

659 Answers

Ed Mac

Level 3 Expert

731 Answers

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

Are you a Delta Faucet Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...