Question about Televison & Video

1 Answer

Trying to set up romote fortv - Televison & Video

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a Sansoui TV and an Universal Remote that is with RCA and I can not program it. Please advise.

Posted on May 10, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Samsung sp50l2hx trying to set up hd antenna. I

Go into the menu and select antenna and do auto programm.

Mar 25, 2010 | Televison & Video

1 Answer

The tv won't turn on. The romote doesn't work and

Could be the powersupply unit has gone out or the control interface logic board I would hire a repairman and have him do some logistics on this TV to find out the issue as it could be 1 of 2 things. 1. no power to the rest of unit due to fuse or bad capcitor 2. controller board not working out of logistics. Ether way here its worth the fix and you should look into it you be glad you did because of todays economy it would cost you Hundreds to replace this GEM!!

Sep 01, 2009 | Philips 55PW9363 55" Rear Projection...

1 Answer

D52w20 will not turn on romote or front button

Bad HV Splitter and / or flyback transformer......
chassis needs to be pulled...technical repair......T.

Mar 06, 2008 | Televison & Video

1 Answer

RCA Projection TV

ok lets begin... shut off? the set staying off. NO POwer at all.. does the set try to come on. does the set have a blinking led on front. have you tried unpluging then waiting 30 min then trying to turn it on again.. this set has a processor and when it detectect any fault will shut the set down

Mar 03, 2008 | RCA D52W20 52" Rear Projection HDTV-Ready...

2 Answers

Three screens at once!

This is a convergence problem. Go into menu, select setup, select convergence, and run auth converge. If there is no failure in the tv then this will correct the problem. This model does have chronic convergence failures and most times either the convergence power supply must be replaced. Occasionally the problem is the convergence amp pcb and rarely the deflection bd can cause the problem.

Feb 05, 2008 | RCA HD52W56 52" Rear Projection HDTV

1 Answer

Television is out of convergement

You need new convergence amp ICs there are two of them replace both. They cost around 10.00 each.

Feb 02, 2008 | Toshiba 55HX70 55" Rear Projection...

2 Answers

Picture black and white , no color

try resetting the tv back to factory settings under within the tv's menu setting you should find a setting to reset the tv, most likely all the color and contract settings may have been tunred down,

Sep 08, 2007 | Sony KP-61V90 61" Rear Projection...

1 Answer

Can not reset tv

These sets have a common problem with the front panel buttons sticking and not allowing the set to turn on. Unplugging the control panel and using the remote to turn the set on normally diagnoses that problem (If you try this, remember that once the set is origionally plugged in, it takes about a minute and half before the set can be turned back on. Another problem could be in the convergence circuit. If you hit the power button and the indicator light comes on and shuts off then that is the circuit that is most suspect. The -24 volt line fusible link as well as the 24 volt line will open up if the convergence IC shorts out. There is a way to diagnose this set by pushing in and holding the menu and device button on the set at the same time until the indicator light starts flashing. There are two sets of flashes, such as, 2 flashes and then 3 flashes. Hope this helps.

Jun 03, 2007 | Mitsubishi WS-55513 55" Rear Projection...

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

The Knight
The Knight

Level 3 Expert

69804 Answers

Electro Med Services...
Electro Med Services...

Level 3 Expert

6384 Answers


Level 3 Expert

63990 Answers

Are you a Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides